Page 96 / 210
Scroll up to view Page 91 - 95
Section 5, DLP-004
NetVanta 2000 Series System Manual
96
© 2002 ADTRAN, Inc.
61200361L1-1E
9.
Follow the procedures outlined in DLP-003 to save the settings to nonvolatile memory.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Page 97 / 210
61200361L1-1E
© 2002 ADTRAN, Inc.
97
CONFIGURING THE LAN INTERFACE IP ADDRESS
Introduction
When the NetVanta 2000 series is connected to an IP network, there are several IP parameters that must be
set in order for the unit to communicate with the network. These parameters are described in this DLP
along with the procedures for setting them.
Prerequisite Procedures
This DLP assumes the NetVanta 2000 series is connected to a PC and a browser session is active. Refer to
DLP-001 for more details.
Tools and Materials Required
•
No special tools or materials are required.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Page 98 / 210
Section 5, DLP-005
NetVanta 2000 Series System Manual
98
© 2002 ADTRAN, Inc.
61200361L1-1E
DLP-005
Perform Steps Below in the Order Listed
1.
Log in to the NetVanta 2000 series as
admin
(see DLP-001 for details).
2.
From the main menu (located across the top of the screen), select
C
ONFIG
.
If you are connected to the NetVanta 2000 series through the LAN interface,
changing the LAN interface IP address will result in a loss of communication with
the unit. Before changing the LAN IP address, follow the steps in
DLP-012,
Configuring the LAN Interface DHCP Server
to assign the DHCP server a range of
IP addresses on the same subnet as the new LAN IP address.
Page 99 / 210
NetVanta 2000 Series System Manual
Section 5, DLP-005
61200361L1-1E
© 2002 ADTRAN, Inc.
99
3.
From the menu list (located on the left side of the screen), select
N
ETWORK
I
NTERFACE
. This displays
the
E
THERNET
C
ONFIG
page.
4.
Enter the IP address for the LAN side of the NetVanta 2000 series in the
L
AN
IP
field. Enter the
appropriate subnet mask in the field below.
Page 100 / 210
Section 5, DLP-005
NetVanta 2000 Series System Manual
100
© 2002 ADTRAN, Inc.
61200361L1-1E
5.
Scroll to the bottom of the screen and click the
S
UBMIT
button. The screen will blink and you will return
to the Ethernet Config page.
6.
Follow the procedures outlined in DLP-003 to save the settings to nonvolatile memory.
7.
If you are connecting to the unit via the LAN interface, it will be necessary for you to log into the unit
again once the IP address has been changed (see DLP-001 for details).
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
19216811.live