Page 101 / 210
Scroll up to view Page 96 - 100
61200361L1-1E
© 2002 ADTRAN, Inc.
101
CONFIGURING THE WAN INTERFACE USING DYNAMIC OR STATIC IP
ADDRESSING
Introduction
The NetVanta 2000 series supports three IP addressing schemes on the WAN interface -- dynamic, static,
and PPP over Ethernet (PPPoE). This DLP discusses the procedure for using either the dynamic IP or static
addressing schemes.
Prerequisite Procedures
This DLP assumes the NetVanta 2000 series is connected to a PC and a browser session is active. Refer to
DLP-001 for more details.
Tools and Materials Required
•
No special tools or materials are required.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Page 102 / 210
Section 5, DLP-006
NetVanta 2000 Series System Manual
102
© 2002 ADTRAN, Inc.
61200361L1-1E
DLP-006
Perform Steps Below in the Order Listed -- Dynamic Addressing
1.
Log in to the NetVanta 2000 series as
admin
(see DLP-001 for details).
2.
From the main menu (located across the top of the screen), select
C
ONFIG
. The
E
THERNET
C
ONFIG
page will appear.
Page 103 / 210
NetVanta 2000 Series System Manual
Section 5, DLP-006
61200361L1-1E
© 2002 ADTRAN, Inc.
103
3.
Select the
D
YNAMIC
radio button in the
WAN IP T
YPE
C
ONFIGURATION
section.
4.
Scroll to the bottom of the screen and click the
S
UBMIT
button. The screen will blink and you will return
to the Ethernet Config page.
5.
Some Service Providers require the use of a unique DHCP Client Name to acquire an IP address
dynamically. Enter this unique name (given to you by your provider) by selecting Config from the main
menu (located across the top of the screen) and then selecting General from the menu list (located
down the left side of the screen) and typing it in the DHCP Client Name field.
Page 104 / 210
Section 5, DLP-006
NetVanta 2000 Series System Manual
104
© 2002 ADTRAN, Inc.
61200361L1-1E
6.
Follow the procedures outlined in DLP-003 to save the settings to nonvolatile memory.
Perform Steps Below in the Order Listed -- Static Addressing
1.
Connect the NetVanta 2000 series to a PC and initiate an active browser session (see DLP-001 for
details).
2.
From the main menu (located across the top of the screen), select
C
ONFIG
. The
E
THERNET
C
ONFIG
page will appear.
Page 105 / 210
NetVanta 2000 Series System Manual
Section 5, DLP-006
61200361L1-1E
© 2002 ADTRAN, Inc.
105
3.
Select the
S
TATIC
radio button in the
WAN IP T
YPE
C
ONFIGURATION
section.
4.
Enter the IP address of the NetVanta 2000 series WAN interface in the
WAN IP
data field. Enter the
appropriate subnet mask in the fields below.
19216811.live