Page 46 / 149
Scroll up to view Page 41 - 45
Chapter 3 - Commissioning
Configuring the CPE Using the WiMAX Modem Application CD
BreezeMAX Si 4000 CPE
32
Operator Manual
3
Choose the ISP (Internet Service Provider) ConfigFile from the list and click
Next
. The Ready To Install window is displayed.
4
Click
Install
. If your CPE is powered up, click
OK
for performing system
reboot. If not, power on the CPE and click
OK
.
The tool starts the auto-configuration process of the unit settings. It will
change default settings by using the *.ipk file, and then run “reset to factory
default” by using default configuration in the file.
Figure 3-4: Choose Your ISP Window
Figure 3-5: Ready To Install Window
Page 47 / 149
Chapter 3 - Commissioning
Configuring the CPE Using the WiMAX Modem Application CD
BreezeMAX Si 4000 CPE
33
Operator Manual
5
When the installation is complete, an Installation Success window is
displayed. Click
OK
.
6
Click
Finish
. The CPE is now configured with the parameters from the
ConfigFile.
Figure 3-6: Installing Window
Figure 3-7: Installation Succeeded
Page 48 / 149
Chapter 3 - Commissioning
Configuring the CPE Using the WiMAX Modem Application CD
BreezeMAX Si 4000 CPE
34
Operator Manual
Figure 3-8: Installation Complete
Page 49 / 149
Chapter 3 - Commissioning
Configuring the CPE Using the IPKG Upgrade
BreezeMAX Si 4000 CPE
35
Operator Manual
3.4
Configuring the CPE Using the IPKG
Upgrade
This section explains how to use the IPKG (ITSY Package Management System),
provided by the operator, to automatically configure a CPE and sometimes
upgrade its features. Subscribers should use this procedure upon specific
instruction from the operator.
1
From the main menu at the left pane select
Status
and open the
Software
page (
Figure 3-9
).
2
Click
Browse
to upload the
*ipk
file provided for this unit.
3
Click
Upgrade
to apply all the parameters in the IPKG file to this unit.
To upgrade the unit using the IPKG:
Figure 3-9: Status - Software Page
Page 50 / 149
Chapter 3 - Commissioning
Creating a Default Configuration File
BreezeMAX Si 4000 CPE
36
Operator Manual
3.5
Creating a Default Configuration File
This section explains how to create a default configuration file (
*.ipk
) for automatic
configuration. When applying this file to CPEs, all the parameters will
automatically be configured with the values from the file. When resetting the unit
to factory defaults - this file is reloaded, overriding any configuration changes you
may have performed on the CPE.
Creating a configuration file involves converting a *.tar file into an *.ipk file.
When the *.ipk file is ready, copy it onto a CDROM along with the subscriber
documentation and include it in the CPE package.
1
Choose a CPE from which to create the default configuration file.
2
Configure the settings of the CPE as described in this manual.
3
Select
Engineering
from the main menu and open the
Dev Config
page
(
Figure 3-10
).
4
Double-click
Export
. A
*.tar
file is created and you can save it for later
auto-configuration of additional CPEs.
To create a configuration *.
tar
file:
19216811.live