Page 66 / 149
Scroll up to view Page 61 - 65
Chapter 5 - Configuring Internet Parameters
Introduction
BreezeMAX Si 4000 CPE
52
Operator Manual
5.1
Introduction
BreezeMAX Si 4000’s Internet menu allows you to set general Internet
management functions for the unit, including authentication method selection,
security parameters, and setting a Dynamic DNS (Domain Name System)
provider.
BreezeMAX Si 4000model for the 3.5 GHz WiMAX band an IEEE 802.11g and
IEEE 802.11b radio interface for local Wi-Fi communications. The Wi-Fi setup
pages include configuration options for the radio signal characteristics and Wi-Fi
security.
Page 67 / 149
Chapter 5 - Configuring Internet Parameters
Authentication
BreezeMAX Si 4000 CPE
53
Operator Manual
5.2
Authentication
The Authentication page allows you to set the parameters for the authentication
method in order to gain access to the WiMAX network.
The Authentication page includes the following parameters:
IMPORTANT
Do not change parameters in this page unless specifically instructed by your service provider.
Figure 5-1: Internet - Authentication
Page 68 / 149
Chapter 5 - Configuring Internet Parameters
Authentication
BreezeMAX Si 4000 CPE
54
Operator Manual
Authentication Method
- Select one of the following WiMAX security
methods:
»
None - Authentication is disabled
»
EAP-TTLS-MSCHAPV2 (Default) - EAP-Tunneled Transport Layer Security,
supporting the Microsoft version of the Challenge-handshake
authentication protocol, version 2.
»
EAP TLS - EAP-Transport Layer Security
When Authentication is enabled, set the following parameters:
User Name
- Enter the user name supplied by the service provider (Default:
Password
- Enter the user password supplied by the service provider). Default:
quickynikynyoky
Password Confirmation
- Re-enter the user password to confirm it.
Page 69 / 149
Chapter 5 - Configuring Internet Parameters
Security
BreezeMAX Si 4000 CPE
55
Operator Manual
5.3
Security
The Security page enables to configure the firewall feature. The firewall feature
can be used to block unauthorized access while allowing only authorized
communications from the Internet network. This feature also allows the device to
be managed over the Internet by authorized personnel.
The Security page includes the following parameters:
Enable Web login from Internet
- Select this check-box to access the device
from other networks. When web login is enabled and a port is defined, you can
access the device from another network Simply by opening a browser and
entering the address of the device (Default: Disabled)
Web Login Port from Internet
- Define a specific port number for security
access control (the default port number is 8080). Available only if Web Login
from Internet is enabled.
Figure 5-2: Internet - Security
Page 70 / 149
Chapter 5 - Configuring Internet Parameters
Security
BreezeMAX Si 4000 CPE
56
Operator Manual
Enable ping from Internet
- Enables to set the unit to respond to ping
commands for troubleshooting purposes.
To issue a Ping command from internet, enter the destination address (either
your PC or another PC as required
and click
Ping
. The response will be
displayed in the area below the Ping button.
NOTE
The Enable Ping From Internet option is used for testing, therefore it is recommended to keep it
disabled during normal operation.
You can ping and receive a replay from the net while ping is disabled. However, when this option is
disabled, you cannot ping from WAN to the unit.
19216811.live