19216811.liveChapter 2 - CPE Installation
Installation Procedure
BreezeMAX Si 4000 CPE
17
Operator Manual
3
Observe the Indicator LEDs. When you power on the BreezeMAX Si 4000,
verify that the Power LED turns on and that the other LED indicators start
functioning as described in
Table 2-1
and
Table 2-2
.
4
Do one or both of the following:
»
Connect your PC - Connect a Category 5 or better Ethernet cable to the
BreezeMAX Si 4000’s LAN port and the other end to the network port of
your PC. Alternatively, you can connect the LAN port to an Ethernet switch
or other devices. Make sure the length of each cable does not exceed 100
meters (328 ft).
»
Connect your PC using WiFi (if available) - Click the WiFi icon
(lower
right corner of PC); Click Find WLAN. Click the name of WiFi network and
click Connect.
If your PC is powered on, the RJ-45 LAN port LEDs on the BreezeMAX Si 4000
turn on to indicate valid Ethernet links.
5
Align the unit so that you receive the strongest signal by monitoring the
WiMAX LEDs on the front panel of the unit.
Functioning as a gateway, the unit routes traffic between a WiMAX service
provider’s base station and the PCs or notebooks in the local network.
6
Connect a standard (analog) telephone set to the BreezeMAX Si 4000’s VoIP
port using standard telephone cable with RJ-11 plugs.
The BreezeMAX Si 4000 enables VoIP calls to be made through the unit using
a standard (analog) telephone set connected to a VoIP port. Standard Session
Initiation Protocol (SIP) technology is used to make VoIP calls. You must
access the web interface and configure settings for your SIP service provider
before you can make VoIP calls. The VoIP service may be configured remotely
or locally by web.
CAUTION
To avoid damage to the product, use ONLY the power adapter supplied with the unit.
NOTE
If the BreezeMAX Si 4000 displays a weak WiMAX receive signal, try moving it to another location,
or position it differently.