Chapter 2 - CPE Installation
Installation Procedure
BreezeMAX Si 4000 CPE
16
Operator Manual
2.2
Installation Procedure
Before installing the BreezeMAX Si 4000, verify that you have all the items listed
in the package checklist above. If any of the items are missing or damaged,
contact your local WiMAX provider.
2.2.1
Guidelines for Positioning the Unit
The BreezeMAX Si 4000 can be installed indoors on any horizontal surface, such
as a desktop or shelf. Be sure to select a suitable location for the device. Consider
these points:
Select a cool, dry place, which is out of direct sunlight. To improve overall
performance, choose an upper floor location near a window or outside wall.
Leave adequate space (approximately 2”/5 cm) on all sides for proper air flow.
Locate the unit near an AC power outlet that provides 100V to 240V.
Avoid metal obstacles such as furniture, office equipment or metal film
anti-glare windows in the transmission path.
Position the unit at least 6.5 feet/2 meter away from any WiFi device (if used),
to avoid interference.
2.2.2
Installing the Unit
The BreezeMAX Si 4000 is a plug-and-play device, so once it has been connected
to your PC and powered up, it is fully operable.
1
Place the unit on a flat horizontal surface indoors. Use the rotating base to
stabilize the device.
2
Connect the power cable to the power jack located on the rear panel of the
unit. Connect the other end of the power cord to the AC mains. The unit will
take 1-2 minutes to boot up and find a nearby base station signal.
CAUTION
The BreezeMAX Si 4000 is an indoor unit and must not be installed outdoors.
19216811.live