Page 41 / 152
Scroll up to view Page 36 - 40
39
provider here. You can choose ‘Obtain an IP address automatically’ (equal to
DHCP, please refer to ‘Cable Modem’ section above), or ‘Use the following IP
address’ (equal to static IP address, please refer to ‘PPPoE xDSL’ section
above).
WAN interface settings must be correctly set, or the Internet connection will
fail even if the PPTP settings are correct. Please contact your Internet service
provider if you do not know what you should place in these fields.
Now please go to the L2TP settings section:
Here are descriptions of each setup item:
User Name (1):
Please the input user ID (user name) assigned by
your Internet service provider here.
Password (2):
Please input the password assigned by your Internet
service provider here.
L2TP Gateway (3):
Please input the IP address of the PPTP gateway
assigned by your Internet service provider here.
MTU (4):
Please input the MTU value of your network connection
here (If you do not know, you can use the default value).
Connection
Please select the type of Internet connection you
type (5):
wish to use (please refer to last section for detailed
descriptions).
1
2
4
3
5
7
6
Page 42 / 152
40
Idle Time
Please input the idle time out of Internet
Out (6):
connection you wish to use (refer to last section for
detailed descriptions).
When you finish with all settings, please click ‘OK (7); if you want to return to
the previous menu, click ‘Back’.
4.6 Setup procedure for ‘Telstra Big Pond’:
This setting only works if you are using Telstra big pond’s network service in
Australia. You need to input:
User Name (1):
Please input the user name assigned by Telstra.
Password (2):
Please input the password assigned by Telstra.
Assign login
Check this box to choose the correct login
server manually (3): server by yourself.
Server IP Address(4):Please input the IP address of the login server here.
When you finish with all settings, click ‘OK (5); if you want to return to the
previous menu, click ‘Back’.
1
2
3
4
5
Page 43 / 152
41
When all settings are finished, you will see the following message displayed
on your web browser:
Please click the ‘Apply’ button to prepare to restart the X650, and you will see
this message:
Please wait for about 40 seconds, then click the ‘OK!’ button. You will be back
to the router management interface again and the router will be ready with new
settings.
Page 44 / 152
42
5 Basic Setup
In this chapter, you will learn how to change the time zone, password, and
remote management settings of the X650. Please start your web browser and
log on to the router web management interface, then click the ‘General Setup’
button on the left or click the ‘General Setup’ link at the upper-right corner of
the web management interface.
Page 45 / 152
43
5.1 Time zone and time auto
‐
synchronization
Please click ‘System’ on the left of the web management interface menu, then
click ‘Time Zone’, and the following message will be displayed on your web
browser:
Please select the correct time zone from the ‘Time Zone’ drop-down list, and
input the IP address or host name of the time server. If you want to enable the
daylight savings setting, please check the ‘Enable’ box and set the duration of
the daylight setting. When you finish, click ‘Apply’. You will see the following
message displayed on your web browser:
Press ‘Continue’ to save the settings changes made and return to the web
management interface; press ‘Apply’ to save the settings made and restart the
router so the settings will take effect after it reboots.
NOTE: You can refer to the instructions given in the last chapter
(‘Using Quick Setup’) for detailed descriptions of time zone settings.
19216811.live