Page 21 / 47
Scroll up to view Page 16 - 20
21
Step4.
Set
SSID Configuration
in the following figure:
Service Set Identifier (SSID) is used to uniquely identify your WLAN. If
you enable
SSID Broadcast
, the gateway will broadcast the SSID, and
other device can detect and connect with it.
Step5.
Set
Security Configuration
in the following figure:
Encryption will keep your traffic from being unauthorized monitor and
access, select one encryption mode from the list, and then set key
and/or algorithm for it.
Page 22 / 47
22
Step6.
Show the Configuration
in the following figure:
Make sure that all the parameters shown in the figure are correct, and
then click
Apply
.
4.2.3 WAN Connection
Click
WAN Connection
, you can configure how to connect to the
Internet
in the following figure:
There are three connection mode:
1.
Auto Connect
: The router will automatically connect to WAN when
it is powered on.
2.
On Demand Connect
: .The connection will be established when
data transmission are required. Router will disconnect from the Internet
if there is no data traffic going through it during the
Max Idle Time
.
Page 23 / 47
23
3.
Manual Connect
: Connect to Internet manually.
Click
Apply
to confirm your configuration, and then the PPP
connection status will be shown in the figure.
4.2.3 3G Settings
1. Wireless Info
Select
3G Settings
→
Wireless Info
, the 3G wireless information is
shown in the following figure:
Click
Refresh
to update the wireless information.
2. Network Select
Select
3G Settings
→
Network Select
, the Band Selection Mode is
shown in the following figure:
Page 24 / 47
24
Automatic
: Router searches for valid network according to the
wireless network.
Only WCDMA
: Router searches for WCDMA network only.
Only GSM
: Router searches for GSM network only.
Click
Apply
to confirm your configuration.
3. APN Setting
Select
3G Settings
→
APN Setting
, the APN parameters are shown in
the following figure:
APN Setting
: APN address mode. If a fixed APN is provided by
your service provider, select
Manual APN
. Otherwise select the
Auto APN
, and the router will automatically obtain this parameter.
APN
: APN string.
Dial No.
: This dial number is used for data service connection.
PDP Type
: Packet Data Protocol (PDP) Type IP is recommended
unless service provider instruct others.
PDP Setting
:
PDP address mode. If a fixed IP address is given
by your service provider, select
Manual PDP
. Otherwise select
the
Auto PDP
and the router will automatically obtain this
parameter.
Page 25 / 47
25
DNS
: If a fixed IP address is given by your service provider, then
choose
Manual DNS. otherwise ,choose
Auto DNS
,and router
will automatically obtain parameters.
Authentication
: Password Authentication Protocol (PAP)
provides a simple method without encryption for the peer to
establish its identity using a 2-way handshake. Challenge-
Handshake Authentication Protocol (CHAP) is used to periodically
verify the identity of the peer using a 3-way handshake.
User Name
: User name is used to obtain authentication from the
ISP when the connection is established
Password
: Password is used to obtain authentication from the
ISP when the connection is established.
Click
Add
to define a new APN profile, and then click
Save
to save the
profile. Click
Set default
to set the parameters to their default value.
Select one profile and click
Delete
to delete it.
Note
：
You can not edit or delete the current default APN profile.
4.2.5 Router
1. LAN
Select
Router
→
LAN
, the LAN parameters are shown in the following
figure:
19216811.live