Page 36 / 47
Scroll up to view Page 31 - 35
36
Default Policy
: Set how to handle the packet if none of the rules
matches.
MAC address
: Set the MAC address that will be filtered.
Dest IP Address
: Set the destination IP address that will be
filtered.
Source IP Address
: Set the source IP address that will be filtered.
Protocol
: Set which protocol will be used for filtering.
Dest Port Range
: Set the destination port numbers that will be
filtered
Source Port Range
: Set the source port numbers that will be
filtered.
Action
: Set how to handle the packet if it matches with the rule.
Page 37 / 47
37
Comment
: type comment for the filter settings.
Note
：
Filtering rules are matched one by one, if met this provision, it
will not continue to match the rules listed below.
Click
Apply
to confirm your configuration. Click
Delete
to delete the
rule which you selected. Click
Reset
to clear what you select or input.
To add a new rule:
a) Select
Enable
and click
Apply
in the
Basic Settings
area.
b) Input the detail information in the
Mac/Ip/Port Filtering
area.
c) Click
Apply
in the
Mac/Ip/Port Filtering
area.
2. URL Filtering
You can setup content filter to restrict the improper content access.
Select
Firewall
→
URL Filtering
, the URL Filtering is shown in the
following figure:
Type URL address, and then click
Add
to add the URL address into the
filtering list. The new URL filtering item will be shown in the
Current
Webs URL Filters:
field.
3. Port Forwarding
You can setup virtual servers to provide services on the Internet.
Select
Firewall
→
Port Forwarding
, the virtual server settings is shown
in the following figure:
Page 38 / 47
38
If you select
Enable
, the Virtual Server Settings will appear:
IP Address
: Set IP address for the virtual server.
Port Range
: Set port numbers for the virtual server.
Protocol
: Set protocol for the virtual server.
Comment
: Type comment for the virtual server settings.
Select
Enable
, and input the detail information in the
Virtual Server
Settings
area, and then click
Apply
to add a new rule. Click
Delete
to
delete the rule which you selected. Click
Reset
to clear what you
select or input.
4. DMZ
Page 39 / 47
39
You can setup a De-militarized Zone(DMZ) to separate internal
network with the Internet. Select
Firewall
→
DMZ
, the DMZ setting is
shown in the
following figure:
If you select
Enable
, set the DMZ IP address ,and then click
Apply
to
confirm your configuration.
5. System Security
You can configure system firewall to protect AP or router from being
attacking. Select
Firewall
→
System Security
, the system security
setting is shown in the
following figure:
Allow
or
Deny
the remote management function and
Enable
or
Page 40 / 47
40
Disable
ping from WAN filter on requirement, and then click
Apply
.
4.2.8 Advanced
1. Status
Select
Advanced
→
Status
, the system information is shown in the
following figure:
2. Statistics
Select
Advanced
→
Statistics
, the system statistics information is
shown in the
following figure:
3. Management
Select
Advanced
→
Management
, the administrator settings
information is shown in the following figure:
19216811.live