Page 66 / 131 Scroll up to view Page 61 - 65
User Manual for T2-B-Gawv1.4U10Y.BI
Teracom Limited
63
An ISO Certificed Company
Field
Description
IP Address
The management IP address of the LAN on
the modem. By default, it is 192.168.1.1.
Subnet Mask
The subnet mask of the IP address. By
default, it is 255.255.255.0.
Virtual IP Address
Select it, you can access the Internet through
the virtual IP address. By default, it is not
selected. After you select it, you are required
to enter
IP Address
and
Subnet Mask
.
MTU
The maximum transmission unit. By default, it
is 1500.
Enter the required parameters and click
Apply
to take it effect.
3.4.3.2
IPv6 Address
Click
IPv6 Address
in the
Local Network Configuration
page and the following
page appears. In this page, enter the unicast IPv6 address of the LAN side, which
should not begin with fe8.
3.4.3.3
DNS Client
Click
DNS Client
in the
Local Network Configuration
page and the following
page appears. A DNS server is any PC registered to join the DNS. A DNS server
Page 67 / 131
User Manual for T2-B-Gawv1.4U10Y.BI
Teracom Limited
64
An ISO Certificed Company
runs special-purpose networking software, features a public IP address, and
contains a database of network names and addresses for other Internet hosts.
3.4.3.4
DNS Relay
Click
DNS Relay
in the
Local Network Configuration
page and the following
page appears. The DNS relay responds to DNS requests from the LAN side.
Usually it transmits DNS requests to other DNS servers to parse, the addresses of
the DNS servers are obtained through the DHCP client.
Note:
Dial-up under bridge mode, the DNS setting is inefficient. When the DNS sends
the request, the DNS client parses them by itself. If the parse is failed, it is
delivered to a superior DNS server. DNS client can record some domain
Page 68 / 131
User Manual for T2-B-Gawv1.4U10Y.BI
Teracom Limited
65
An ISO Certificed Company
information to the buffer. DNS relay does not parse them, and all the requests
are transferred to a superior DNS server.
3.4.3.5
DNS LAN Host
When you enter a domain name into a browser, the PC must send a request to a
DNS server to obtain the corresponding IP address immediately. The DNS server
attempts to look up the domain name in its local host database immediately.
Click
DNS LAN Host
in the
Local Network Configuration
page and the following
page appears.
Click
Create a New DNS hostname entry manually
and the following page
appears.
The following table describes the parameters of this page.
Field
Description
Host Name
Enter the domain name.
IP Address
Enter the valid IP address of LAN host.
Page 69 / 131
User Manual for T2-B-Gawv1.4U10Y.BI
Teracom Limited
66
An ISO Certificed Company
Click
Apply
to add the host name and IP address as DNS server. Then other hosts
can access the PC through the domain name.
3.4.4
Voice Configuration
Voice over Internet Protocol (VoIP) is a technology that allows you to make voice
calls using a broadband Internet connection instead of a regular phone line.
3.4.4.1
System Settings
Choose
Voice Configuration
>
System Settings
and the following page appears.
In this page, you can view and modify the settings of system wide voice.
Cid Type:
Calling identity delivery (CID) supports field services kit (FSK), dual-tone
multi-frequency (DTMF).
Select
Enable (SIP)
from the
VoIP Functionality
drop-down list, select the IP
interface name and correct region.
Click
Go To Advanced view
and the following page appears. In this page, you can
configure more settings of the VoIP parameter.
Page 70 / 131
User Manual for T2-B-Gawv1.4U10Y.BI
Teracom Limited
67
An ISO Certificed Company
3.4.4.2
SIP
Click
SIP
in the
VoIP Configuration
page and the following page appears. In this
page, you can view and modify the related settings of the SIP protocol.

Rate

4.5 / 5 based on 2 votes.

Popular Teracom Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top