Page 31 / 139
Scroll up to view Page 26 - 30
ADSL2/2+ Router
Route:
displays routing table of the device as shown in the figure
below:
ARP:
displays the device’s LAN ports, IP and MAC addresses of the
PCs that are wirelessly connected as shown in the figure below:
- 31 -
Page 32 / 139
ADSL2/2+ Router
4.2 Advanced Setup
Advanced Setup:
Consists of 14 submenus including Connection
Mode/
WAN
Service/LAN/DHCP
Setting/NAT/Security/Time
Restriction/Quality
of
Service/Routing/DNS/DSL/UPnP/
Interface
Grouping and Multicast as shown in the figure below:
4.2.1 Connection mode
Connection Mode
This router supports two connection modes: DSL mode and Ethernet
mode. Select DSL mode, if you access Internet through telephone line
and Ethernet mode through network cable. By default, system is in DSL
mode.
- 32 -
Page 33 / 139
ADSL2/2+ Router
To
enter
the
connection
mode
interface,
click
“Advanced
Setup”---“Connection Mode”.
Select a proper connection mode and
then click the “Apply” button.
1. In DSL mode, you are required to configure parameters for ATM
interface.
To enter the ATM Interface page, click “Advanced Setup”---“Connection
Mode” (Select DSL mode and click “Apply”) --- “WAN Service”---ATM
Interface. And then click “Add” to configure the relevant parameters.
On this page, you can configure VPI and VCI values (consult your local
ISP if you are not clear). For other options, keep the defaults and click
the “Apply/Save” button.
- 33 -
Page 34 / 139
ADSL2/2+ Router
2. In Ethernet modes, you are required to configure parameters for
Ethernet interface.
To enter the ETH Interface page, click “Advanced Setup”---“Connection
Mode”
(Select
Ethernet
mode
and
click
“Apply”)
---
“WAN
Service”---“ETH Interface”. And then click the “Add” button to configure
relevant parameters.
The Ethernet interface configured on this page is used as a WAN port.
You can select only one LAN interface to function as a WAN port. Once
you finish, click the “Apply/Save” button.
4.2.2 WAN Service
1. WAN Configuration in DSL Mode
PPP over Ethernet (PPPoE)
Click “Advanced Setup”—“Connection mode”(Select DSL mode and
click “Apply”)---“WAN Service”---“ATM Interface” (Keep default DSL link
- 34 -
Page 35 / 139
ADSL2/2+ Router
type
EOA
unchanged,
and click the
“Apply/Save” button. For details, refer to 4.2.1----1) ---“Connection
Setting” to enter WAN service setup interface (page1) and then click the
“Add” button there to select a WAN service type on page 2.
Page 1
Page 2
Select PPP over Ethernet (PPPoE), modify the service description if
necessary and then click “Next” on page 2 to enter the page below
(page 3):
- 35 -
19216811.live