Page 16 / 135
Scroll up to view Page 11 - 15
Wireless AC1750 Dual-band Gigabit Router
15
If you used to access Internet simply by connecting your PC
directly to the modem with no need to configure any settings on
your PC.
Then select DHCP, enter a security key and then click
OK.
Note:
DHCP is the default Internet connection type. If you need other
connection types, please go to Chapter 4> WAN settings.
2.6 Verify Internet Connection Settings
After finishing settings on home page, click the Advanced button
from right top corner there and then click Running Status-> WAN
Status to check the Internet connection status.
A. If you find "Connected" and a WAN IP address displayed
there (as shown below), you can now connect to the device
using an Ethernet cable to access Internet.
Page 17 / 135
Wireless AC1750 Dual-band Gigabit Router
16
B. If "Disconnected" (or "Not connected") and no WAN IP
address are displayed (as seen below), connection between
the Internet-enabled modem (or broadband service) and your
device may have failed. Please double check or re-connect all
involved devices and cables properly and then refresh the
page. If nothing is wrong, "Connecting" or "Connected" will be
displayed.
Page 18 / 135
Wireless AC1750 Dual-band Gigabit Router
17
C. If "Connecting" is displayed and no WAN IP address is
seen, try refreshing the page five times. And if it still displays
"Connecting" try the following steps:
a. Click the Network menu and then click "MAC Clone". On
the MAC Clone interface, click on the "Clone MAC" button, and
then click "Save". Settings will take effect after device reboot.
Page 19 / 135
Wireless AC1750 Dual-band Gigabit Router
18
b. Go back to the Status screen, refresh it a few times. If you find
"Connected" and a WAN IP address displayed there, you can
now connect to the device using an Ethernet cable to access
Internet. If you still see "Connecting" there, please click Tools->
Reboot to reboot the device.
c. After device reboot, go back to the Status screen, refresh it a
few times. If you find "Connected" and a WAN IP address
displayed there, you can now connect to the device using an
Ethernet cable to access Internet. If you still see "Connecting"
after trying above solutions, verify that your PC is able to access
Page 20 / 135
Wireless AC1750 Dual-band Gigabit Router
19
Internet when it is directly connected to the modem and contact
our technical staff for help.
2.7 Wireless Settings
2.7.1 Wireless-Basic Settings
If you want to create a WLAN, simply click Wireless-> Basic
Settings.
Please change the SSID
（
Wireless Network name
）
,
you can name it whatever you like. Leave other options
unchanged unless necessary and then click OK.
You can also
change the SSID and channel settings for the 5G wireless
network if you like.
19216811.live