Page 31 / 111
Scroll up to view Page 26 - 30
Huawei Technologies Proprietary
21
2)
Select Uninstall.app.
3)
Press <Next> button to start uninstalling the process.
Page 32 / 111
Huawei Technologies Proprietary
22
4)
If the USB cable is not unplugged when the software is
removed from your computer, the message will be
appeared. Unplug the cable and click <OK> button.
5)
After the end of uninstalling process, select the option
Restart Now
and then click on <Finish> button to reboot
your computer.
Page 33 / 111
Huawei Technologies Proprietary
23
IV. Install USB driver for Windows
To install the USB driver in Windows system, you must execute
“MT882Driver.exe” contained on the CD-ROM, which is provided
with the modem.
1)
Double click “MT882Driver.exe” to open the Setup Wizard
window.
2)
Click <Next> button and ready to install.
Page 34 / 111
Huawei Technologies Proprietary
24
During the installation, it doesn’t need any interference from
your side. If you are using Windows XP/2000, a new “Local Area
Connection” will be built for USB port while the installing completed.
2.3.2
Connecting ADSL Line
Simply plug one end of the telephone line into the Modem port
of the splitter and insert the other end into the ADSL port on the rear
panel of the MT882.
Use another telephone line to connect the splitter and the phone
jack on the wall.
2.3.3
Connecting the Computer to the MT882
Use a straight-through cable to connect your PC and the MT882.
You can connect the MT882 directly to a 10/100Base-TX Ethernet
adapter card on your PC with the provided Ethernet cable as shown
in Figure 2-1
Page 35 / 111
Huawei Technologies Proprietary
25
(1) Computer
(2) RJ-11 Tel line
(3) Phone
(4) RJ-45 Ethernet cable
(5) Splitter
(6) Phone jack
(7) MT882
(8) RJ-11 Tel Cable
Figure 2-1
cable connection
2.3.4
Connecting Ethernet LAN to the MT882
MT882 may be connected to any 10/100Base-TX Ethernet port.
When connecting the MT882 to any Ethernet device that is capable
of operating at speeds higher than 10Mbps, be sure that the device
has auto-negotiation mode enabled for the connecting port.
Use a cross-over cable to connect the MT882 and the upstream
port of a switch or hub. Be sure that the cable connecting the LAN to
the MT882 does not exceed 100 meters.
19216811.live