Page 541 / 794
Scroll up to view Page 536 - 540
Vigor2860 Series User’s Guide
527
4.
The Maintenance profile dialog appears.
In the field of Profile Name, type a name for such maintenance profile; check Enable;
and choose the one you want to perform firmware upgrade from Device Name drop
down list. From the Action Type, choose Firmware Upgrade. Type the file/path of the
newest firmware or click Select to locate it. Specify the Schedule profile. At last, click
OK
.
5.
Now, a new maintenance profile has been created.
6.
Click
Now
to perform the firmware upgrade immediately for Vigor2850.
7.
Wait for several minutes for firmware upgrade.
Page 542 / 794
Vigor2860 Series User’s Guide
528
8.
Then check the device information for the managed device if the firmware upgrade is
successful or not. Click
Managed Devices List
.
9.
Click the icon of Vigor2850 and click
Edit
and view
the software version. Another way
to check if the firmware upgrade is completed or not, simply open
Central VPN
Management>>Log & Alert
.
Page 543 / 794
Vigor2860 Series User’s Guide
529
4.17 How to setup Load Balance for Packets?
The following figure shows a simple application of load balance. WAN1 and WAN2 can be
used to access into Internet. The PC in LAN1 can send the data to the remote PC through the
specified WAN1.
1.
Access into web user interface of Vigor2860 series. Open
Load-Balance/Route Policy
.
2.
From the following web page, simply click index number #1.
Page 544 / 794
Vigor2860 Series User’s Guide
530
3.
In the following page, check
Enable
; set Dest IP Start and Dest IP End with 203.65.1.35
and 203.65.1.35; choose WAN1 as the
Interface
; click
default gateway
; do not check
Auto Failover To The Other WAN
.
4.
After finished the above settings, click
OK
to save the configuration.
Now, the packets sent to the remote PC (IP address: 203.65.1.35) will be forced to pass
through WAN1.
Page 545 / 794
Vigor2860 Series User’s Guide
531
4.18 How to authenticate clients via User Management
Before using the function of User Management, please make sure
User-Based
has been
selected as the
Mode
in the
User Management>>General Setup
page.
With
User Management
authentication function, before a valid username and password have
been correctly supplied, a particular client will not be allowed to access Internet through the
router. There are three ways for authentication:
Web
,
Telnet
and
Alert Tool
.
19216811.live