19216811.liveDSL-2750U User Manual
28
Dial on demand
: Within the preset time, if the modem does not detect data
flow , the modem automatically stops the 3G connection. Once it detects
data flow (e.g. access to a webpage), the modem restarts the 3G dialup.
Dial Delay (in sec.)
: The 3G delays dial after the DSL is disconnected.
Default WAN Connection Select
: You can select DSL or 3G from the
drop-down list.
WAN backup mechanism
: The 3G connection is used as backup for the
DSL connection.
–
DSL
: If the DSL is disconnected, the 3G starts to dial.
–
IP connectivity
: If the system fails to ping the specified IP
address, the 3G starts to dial.
After adding the settings, click the
Apply/Save
button to save the settings.
You may also click the
auto setting
button to automatically configure the 3G
connection.
After clicking the
Apply/Save
button, the settings will take effect.
Note:
When there is no DSL WAN connection, insert the 3G network card, and the
system will perform a dial-up automatically. If the DSL WAN connection and the
3G connection coexist, the DSL WAN connection takes priority over the 3G
connection. When the DSL WAN connection starts to perform a dial-up, the 3G
connection will be disconnected. If the DSL WAN connection has been
established, you may manually perform a 3G dial-up, and then the DSL WAN
connection will be disconnected.
4.2.4
Wireless Connection
This section includes the wireless connection setup wizard and WPS setup wizard.
There are two ways to setup your wireless connection. You can use the
Wireless
Connection Setup Wizard
or you can manually configure the connection.
Choose
Setup
>
Wireless Connection
. The
Wireless Connection
page shown in
the following figure appears.