Page 11 / 103
Scroll up to view Page 6 - 10
DSL-2750U User Manual
8
(3)
Plug the 3-Pin Power Supply/Lightning Protection Unit into the wall outlet
and then connect the other end of it to the
Power
port of the router (12V DC
IN).
The following figure shows the connection of the Router, PC, and telephones.
4
About the Web Configuration Interface
This chapter describes how to configure the Router by using the Web-based
configuration utility.
4.1
Access the Router
Configuring IP Address of the Network Card
Page 12 / 103
DSL-2750U User Manual
9
Configure TCP/IP properties of your network card to
Obtain an IP address
automatically from modem
, or set the IP address of the computer with the same
network mask of the modem.
For example, if the IP address of Router is
10.0.0.2/255.255.255.0, you can set the
IP address of the computer to
10.0.0.x/255.255.255.0
. The range for x is from 3 to
254.
The following is the detailed description of accessing the device for the first time.
Step 1
Open Internet Explorer (IE) browser and enter
.
Step 2
The
Login
page shown in the following figure appears. Enter the user
name and password.
The default user name and password are
admin
and
admin
respectively.
If you log in as the Administrator successfully, the page shown in the following
figure appears.
Page 13 / 103
DSL-2750U User Manual
10
If the login information is incorrect, click
Try Again
in the page that pops up to log
in again.
4.2
Setup
4.2.1
Wizard
Wizard
enables fast and accurate configuration of the Internet connection and
other important parameters. The following sections describe these various
configuration parameters.
When subscribing to a broadband service, you should be aware of the method by
which you are connected to the Internet. Your physical WAN device can be
Ethernet, DSL, or both. Technical information about the properties of your Internet
connection are provided by your Internet Service Provider (ISP). For example, your
ISP should inform you whether you are connected to the Internet using a static or
dynamic IP address, or the protocol, such as PPPoA or PPPoE, that you use to
communicate over the Internet.
Step 1
Choose
Setup
>
Wizard
. The page shown in the following figure
appears.
Page 14 / 103
DSL-2750U User Manual
11
Step 2
Click
Setup Wizard
. The page shown in the following figure appears.
Step 3
There are five steps to configure the device. Click
Next
to continue.
Step 4
Change Device Login Password.
The default password of admin account is "
admin
". In order to secure your network,
please modify the password. Note: Confirm Password must be the same as "
New
Password
". Of course, you can click
Skip
to ignore the step and keep the default
password
.
Page 15 / 103
DSL-2750U User Manual
12
Step 5
Set time and date.
Step 6
Configure the Internet connection.
Select the country and ISP. The default settings for the ISP will appear. If
you fail to find the country and ISP from the drop-down lists, select
Others,
and set the VPI and VCI. Click
Next
. If the
Protocol
is
PPPoE
or
PPPoA,
the following page appears.
19216811.live