Page 11 / 91 Scroll up to view Page 6 - 10
DG-HR1400 User Manual
11
2-3 Hardware Installation
Please follow the below mentioned instructions to build the network connection
between your new WIRELESS router and your computers network devices:
1.
Connect your xDSL / cable modem to the WAN port of the router by an Ethernet
cable.
2.
Connect all your computers, network devices (switch / hub) to the LAN port of
the router.
Page 12 / 91
DG-HR1400 User Manual
12
3.
Connect the power adapter (5V DC / 1A) to the wall socket, and then connect it
to the ‘
Power
’ socket of the router.
4.
Please check all LEDs on the front panel. Power LED ‘
PWR
’ should be steadily
ON, WAN and LAN LEDs should be ON. Check if the computer/network device
connected to the respective port of the router is powered ON and correctly
connected. If power LED ‘
PWR
’ is not ON, or any LED you expected is not ON,
please recheck the cabling.
Page 13 / 91
DG-HR1400 User Manual
13
2-4 Software Installation
Insert the Setup CD into your CD-ROM drive of notebook/desktop computer.
Explore the CD and execute the “
AutoRun.exe
” file. Below given screen will
appear. Click '
Start
' to Continue.
Page 14 / 91
DG-HR1400 User Manual
14
Connect one end of a network cable to the WAN port of the router and the
other end to the DSL/Cable modem. Click ‘
Next
’ to continue.
Connect one end of the provided network cable to one of the LAN ports (1~4)
of the router and the other end to your computer. Click ‘
Next
’ to continue
with the installation.
Page 15 / 91
DG-HR1400 User Manual
15
Power on the Router. It will take approximately 30 seconds for the router to
boot up completely. Click ‘
Next
’ to continue with the installation.
Ensure the normal indication of all LED’s on the router. If not, try the above
steps again else click ‘
Next
’ to continue.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top