Page 61 / 91 Scroll up to view Page 56 - 60
DG-HR1400 User Manual
61
4-3 Advanced
Click ‘
Advanced
’ menu on the top of the web management interface, and the
following message will be displayed on your web browser:
There are twelve submenus under the Advanced menu:
Access Control List, Port
Triggering, DMZ, URL Block, IP/Port Filter, MAC Filter, DOS Settings,
Dynamic DNS, QoS Setup, UPnP, Routing and Virtual Server
. Click any of them,
and you will be able to configure the corresponding function.
Page 62 / 91
DG-HR1400 User Manual
62
4-3-1 Access Control List
You can specify what kind of service should be enabled in WAN on this page.
Packets available in the ACL list or from IP specified can enter the AP Router.
Choose menu “
Advanced
Access Control List
”, below given screen will be
displayed.
Here is the description of every setup item:
Parameter
Description
WAN Setting
Select WAN or a specific IP address range.
Services Allowed
Specify what kind of service should be enabled in WAN.
Page 63 / 91
DG-HR1400 User Manual
63
4-3-2 Port Triggering
Entries in this table are used to restrict certain types of data packets from your local
network to Internet through the Gateway. Use of such filters can be helpful in
securing or restricting your local network.
Choose menu “
Advanced
Port Triggering
”, below given screen will be displayed.
Here is the description of every setup item:
Parameter
Description
Nat Port Trigger
If you want to enable Nat Port Trigger function, please
select ‘Enable’; otherwise please select ‘Disable’.
Page 64 / 91
DG-HR1400 User Manual
64
Usual Application Name
You can choose the type for the Usual Application
Name on the pull-down list.
User-defined Application
Name
Enter an application name for the rule.
Start Match Port - End
Match Port
The port range for outgoing traffic. An outgoing
connection using this port will “Match” this rule.
Trigger Protocol
The protocol used for Trigger Ports either TCP, UDP,
or TCP/UDP.
Start Relate Port - End
Relate Port
The port range used by the remote system when it
responds to the outgoing request. A response using one
of these ports will be forwarded to the PC that
triggered this rule.
Open Protocol
The protocol used for Incoming Ports Range, either
TCP or UDP, or TCP/UDP.
Nat Type
Incoming mode will allow inbound traffic to specific
incoming port. Outgoing mode will allow outbound
traffic to specific outgoing port.
4-3-3 DMZ
A Demilitarized Zone is used to provide Internet services without sacrificing
unauthorized access to its local private network. Typically, the DMZ host contains
devices accessible to Internet traffic, such as Web (HTTP) servers, FTP servers,
SMTP (e-mail) servers and DNS servers.
Choose menu “
Advanced
DMZ
”, below given screen will be displayed.
Page 65 / 91
DG-HR1400 User Manual
65
Here is the description of every setup item:
Parameter
Description
Enable DMZ
Check this box to enable DMZ function, uncheck this box to
disable DMZ function.
DMZ Host IP
Address
Enter DMZ host IP Address. Specify the LAN IP address of
the PC on which you want to have unrestricted Internet
communication.
4-3-4 URL Block
This page is used to configure the filtered keyword. Here you can add/delete filtered
keyword.
Choose menu “
Advanced
URL Block
”, below given screen will be displayed.
Here is the description of every setup item:
Parameter
Description
URL Blocking Capability
If you want to enable URL Blocking Capability
function, please select ‘Enable’; otherwise please
select ‘Disable’.
Keyword
Enter the keyword that you want to block.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top