Page 71 / 91
Scroll up to view Page 66 - 70
DG-HR1400 User Manual
71
4-3-10 UPnP
This page is used to configure UPnP. The system acts as a daemon when you enable
UPnP.
Choose menu “
Advanced
→
UPnP
”, below given screen will be displayed.
Here is the description of every setup item:
Parameter
Description
UPnP
Select Enable or Disable to enable or disable UPnP function.
Page 72 / 91
DG-HR1400 User Manual
72
4-3-11 Routing
This page is used to configure the routing information. Here you can add/delete IP
routes.
Choose menu “
Advanced
→
Routing
”, below given screen will be displayed.
Here is the description of every setup item:
Parameter
Description
Enable
Check this box to enable the Routing features; uncheck to
disable it.
Destination
Enter the remote destination LAN IP.
Subnet Mask
Enter the remote LAN subnet mask.
Next Hop
Enter the next hop IP.
Metric
Determines the priority of the route. If multiple routes to the
same destination exist, the route with the lowest metric is
chosen.
Page 73 / 91
DG-HR1400 User Manual
73
Static route table
Parameter
Description
State
Shows if Routing rule is Disabled or Enabled.
Destination
Shows the remote destination LAN IP.
Subnet Mask
Shows the remote LAN subnet mask.
Next Hop
Shows the IP of the next hop.
Metric
Shows metric in numeric form.
Page 74 / 91
DG-HR1400 User Manual
74
4-3-12 Virtual Server
The page allows you to configure virtual server, so others can access the server
through the Gateway.
Choose menu “
Advanced
→
Virtual Server
”, below given screen will be displayed.
Here is the description of every setup item:
Parameter
Description
Usual Service Name
You can choose the type for the Usual Application Name
on the pull-down list.
User-defined Service
Name
Enter a name for the rule.
Protocol
The protocol used for this application, either TCP, UDP.
WAN Port
Enter the port that you want to open next to WAN port.
LAN Open Port
Enter the port that you want to open next to LAN port.
LAN IP Address
Enter the IP address of the computer on your local network
that you want to allow the incoming service to.
Page 75 / 91
DG-HR1400 User Manual
75
4-4 Maintenance
Click ‘
Maintenance
’ menu on the top of web management interface, and the
following message will be displayed on your web browser:
There are eight submenus under the Maintenance menu:
Reboot, Firmware
Upgrade,
Backup/Restore,
Password,
Time
and
Date,
System
Log,
Diagnostics-Ping, Diagnostics-Traceroute.
Click any of them, and you will be able
to configure the corresponding function.
4-4-1 Reboot
This page is used to reboot your system with current setting or reset configuration to
default setting.
Choose menu “
Maintenance
→
Reboot
”, below given screen will be displayed.
Here is the description of every setup item:
Parameter
Description
Reboot
Restarts the router for the settings to take effect.
Reset
Restarts the router with factory default setting.
19216811.live