31

Easy Sign On (EZSO)

This special feature makes it easier for you to configure your router so that you can connect to the

internet in a matter of seconds without having to logon to the router GUI for any detail configuration.

This configuration method is usually auto initiated if user is to connect to the internet via Billion's

router for the first time.

After setting up the router with all the appropriate cables plugged-in, open up your IE browser, the

EZSO WEB GUI will automatically pop up and request that you enter some basic information that

you have obtained from your ISP. By following the instructions given carefully and through the

information you provide, the router will be configured in no time and you will find yourself surfing the

internet sooner than you realize.

EZSO window pops up:

Step1:

Set the administration password.

Step 2:

Set the Time Zone.

Step 3:

Configure the WAN interface.

DSL mode

Before configuring with DSL mode, please confirm you have correctly connected the DSL line, and it

is now synchronized.

1.

Select DSL, press

Continue

to go on to next step, press “Done” to quit the setting.

32

2.

Enter the username, password from your ISP, for IP and DNS settings; also refer to your ISP.

Here IPv6 service is enabled by default.

If the DLS line doesn’t synchronize, the page will pop up warning of the DSL connection failure.

3.

Wait while the device is configured (DSL synchronized).

4.

WAN port configuration is success and next to wireless, if you want skip wireless setting, click

Done

.

Click

Done

, web configuration will be loaded, you will enter the web configuration page.

33

5.

After the configuration is successful, click

Next to Wireless

button and you may proceed to

configure the Wireless setting. The 7800VDP(O)X supports dual-band wireless, here you can set to

activate wireless on which band or both and set the SSID and encryption Key.

(1. Leave it empty to

disable the wireless security; 2. Fill in the Key, and the encryption mode will be WPA2-PSK/AES).

6.

Continue to set 5GHz wireless.

7.

Set the VoIP parameters. First user should turn to a VoIP service provider to register a SIP

account, write down the registration information and fill it in the following blanks. For detail, please

refer to

VoIP

.

34

8.

In the above page, click finish to complete the EZSO settings.

Click link

192.168.1.254

, it will lead you to the following page.

35

Ethernet mode

1.

Select

Ethernet,

press

Continue

to go on to next step.

2.

Enter the username, password from your ISP, for IP and DNS settings, also refer to your ISP.

Here IPv6 service is enabled by default.

3.

Wait while the device is configured.

4.

WAN port configuration is success.

Click

Done

, web configuration will be loaded, you will enter the web configuration page.