ZTE ZXHN H108L Router Manual PDF (Setup & Configuration Guide)

Page 16 / 89 Scroll up to view Page 11 - 15

ZXHN H108L Wireless ADSL Router Maintenance Manual

2

Confidential and Proprietary Information of ZTE CORPORATION

Packing List

The package box for a ZXHN H108L includes the following

components, as shown in Table 4.

T

ABL E

4

P

AC K IN G

L

I S T

Component

Quantity

ZXV10 ZXHN H108L Wireless ADSL Router

1

External splitter

1

Power adapter

1

Telephone line

2

Straight-through Ethernet cable

1

ZXHN H108L Wireless ADSL Router User Manual

1

Note:

Components actually delivered depend on the

service provider. If any component is missing or

damaged, immediately contact the service provider.

Please keep the packing box and components well in case

of replacement.

Front Panel

F

IGU RE

1

F

RON T

P

AN EL

Page 17 / 89

Chapter 1 - Introduction

Confidential and Proprietary Information of ZTE CORPORATION

3

There are 9 indicators on the front panel of a ZXHN H108L indicating

the running status of the device, as shown in

Figure 1

. These

indicators are described in

Table 5

.

T

ABL E

5

D

ESCR IPTIONS F OR TH E

I

N DIC ATORS

Indicator

Color

Description

Power

Red/Gr

een



Red:Indicates the power is just connected or it fails to

function.



Green Steady on: Indicates switched on.



Off: Indicates the power has not been connected

DSL

Green



Steady on: Indicates a DSL link is established.



Slow flashing: Indicates no signal is detected.



Fast flashing: Indicates the MODEM is activating.

Internet

Green



Steady on: Indicates operating in Route mode and

the ADSL link is established. The IP data packet of

the MODEM can be transmitted and received normally

(For

example,

the

embedded

PPPOE

link

is

established and a dynamic IP address is allocated.).



Flashing: Indicates operating in Route mode and

there is data packet passing the MODEM.



Off: Indicates operating in Bridge mode or ADSL link

is not established.

Red



Red on:

Device attempted to become IP

connected and failed (no DHCP response, no

PPPoE response, PPPoE authentication failed,

no IP address from IPCP, etc.)

LAN1

LAN2

LAN3

LAN4

Green



Steady on: Indicates a LAN connection is established.



Flashing: Indicates data is transmitting.



Off: Indicates the LAN connection has not been

established

WLAN

Green



Steady on: Indicates the wireless module is on.



Flashing: Indicates wireless data is transmitting.



Off: Indicates the wireless module is off.

Page 18 / 89

ZXHN H108L Wireless ADSL Router Maintenance Manual

4

Confidential and Proprietary Information of ZTE CORPORATION

Indicator

Color

Description

WPS

Green



Steady on: The wireless terminal device is connected

through WPS successfully. The indicator turns off five

minutes later.



Slowly Flashing: The wireless terminal device is

connecting with H108L through WPS.



Fast Flashing: There is error when the wireless

terminal is connecting to H108L through WPS



Off: There is no wireless terminal device connected to

H108L through WPS or the wireless terminal device

has been connected to H108L through WPS for more

than five minutes.

Rear Panel

F

IGU RE

2

R

E AR

P

AN EL

There are 10 ports and buttons on the rear panel of a ZXHN H108L,

as shown in Figure 2. These ports and buttons are described in Table

6.

T

ABL E

6

D

ESC RIPTION S FOR THE

P

OR TS AN D

B

U TTONS

Identification

Description

DSL

RJ-11 connection interface: The equipment is connected to the

ADSL line or splitter via the telephone line.

LAN1-LAN4

RJ-45 connection interface: Connect it to the PC computer or other

network devices using the network cable.

WPS

WPS switch

Page 19 / 89

Chapter 1 - Introduction

Confidential and Proprietary Information of ZTE CORPORATION

5

Identification

Description

WLAN

To turn on / off the Wi-Fi.

Reset

This button is on the bottom of modem. In the power-on state,

you can restore the system to the default configuration by using a

thin needle to press this slot for three seconds or for three

executive times.

ON/OFF

To turn on / off the power.

POWER

Power interface. Connect it to the power adapter.

System Requirements

System requirements for the ZXHN H108L router are as follows:



The user has already subscribed the ADSL or Ethernet service. The

service provider shall provide at least one legal IP address

(allocated either statically or dynamically).



One or more PCs with 10/100M Ethernet Network Interface Card

(NIC).



For wireless access, an external or built-in 802.11b/g/n wireless

adapter is required.



To configure the system via the web page based interface, you

need a web browser such as Internet Explorer (version6.0 or

above), Netscape (version4.7 or above).

Page 20 / 89

ZXHN H108L Wireless ADSL Router Maintenance Manual

6

Confidential and Proprietary Information of ZTE CORPORATION

This page is intentionally blank.

Rate

Popular ZTE Models

Famous Router IPs

Famous Router Companies

Bookmark Our Site

Share