Page 121 / 145
Scroll up to view Page 116 - 120
65xx-A1 Family Router Users Guide
121
Fault Management
The diagnostics screen allows you to run diagnostic tests to check your PTM VDSL connection.
•
Maintenance Domain
— Determine the device that receives and passes through the CFM
(Connectivity Fault Management) frame.
•
Destination MAC Address
—Destination MAC address (where the fault detection packets
will be sent).
•
802.1Q VLAN ID
—Enter the 802.1Q VLAN
Click Set
MD Level
to apply the MD level. Then click
Send Loopback
to send the loopback
frame or
Send Linktrace
to find the maintenance endpoints.
Management
The Management section gives you access to certain setups for the purpose of maintaining the
system, including backing up the configurations, viewing system log, maintaining access control,
updating software, etc.
Page 122 / 145
65xx-A1 Family Router Users Guide
122
Settings
Backup Settings
To save a copy of the configurations that you have made on your router:
1.
From the Settings – Backup page click
Backup Settings
.
The below pop-up screen will appear with a prompt to open or save the file to your
computer.
2.
Click
Save
.
Page 123 / 145
65xx-A1 Family Router Users Guide
123
Update Settings
To load a previously saved configuration file onto your router:
1.
From the
Settings – Update Settings
page, click
Browse
to find the file on your computer.
2.
Click
Update Settings
.
The router will restore settings and reboot to activate the restored settings.
Restore Default
Restore Default will delete all configuration changes you have made and restore the router to
factory default settings.
To restore the factory defaults:
1.
From the
Settings – Restore Default Settings
page click
Restore Default Settings
.
=
2.
Click
OK
when the pop-up window appears confirming that you want to restore factory
default settings to your router.
Page 124 / 145
65xx-A1 Family Router Users Guide
124
The router will restore the default settings and reboot.
System Log
The System Log dialog allows you to view the System Log and configure the System Log options.
To view the System Log
click
View System Log
to check the log file.
Note
: Only configure this if you are instructed by your ISP technician during troubleshooting
sessions.
Page 125 / 145
65xx-A1 Family Router Users Guide
125
The
System Log
page shows the date and time of the recorded event, which facility captured the
event, the severity of the event and a message which describes the event.
Configure System Log
If the log is enabled, the system will log selected events based on their level. The log levels are
•
Emergency
•
Alert
•
Critical
•
Error
•
Warning
•
Notice
•
Informational
•
Debugging.
All events above or equal to the selected log level will be logged and displayed.
19216811.live