TRENDnet TEW-653AP Router Manual PDF (Setup & Configuration Guide)

Given below is full router user manual of TRENDnet TEW-653AP router model. You can also download this manual in PDF Format to read later on your computer.

Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.

Page 1 / 18
TEW-653AP
1.01
Quick Installation Guide
Page 2 / 18
Table of Contents
English
1
1. Before You Start
2. Hardware Installation
2
3. Power-over-Ethnernet Installation
3
1
4. Configure the Access Point
5
5. Mounting
8
Troubleshooting
9
Version 11.16.2009
Page 3 / 18
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
1. Before You Start
Package Contents
Note:
The TEW-653AP only works with Power over Ethernet (PoE) devices that follow the
IEEE 802.3af standard.
System Requirements
?
Web Browser: Internet Explorer (6.0 or higher)
?
A computer with a network adapter properly installed.
?
A network Switch or Hub with an available network LAN port.
?
Power over Ethernet (PoE) Switch (e.g. TPE-80WS) (Optional)
?
Injector (e.g TPE-111GI ) (Optional)
1
?
?
Multi-Language Quick Installation Guide
?
CD-ROM
User’s Guide
?
Cat. 5 Ethernet Cable (1m / 3.3ft.)
?
Power Adapter (12V DC, 1A)
?
Mounting Kit
TEW-653AP
(
)
Page 4 / 18
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
2. Hardware Installation
2
Note
: Locate an optimum location for the Access Point. The best place for the Access
Point is usually at the center of your wireless network. Please connect the computer
configuring the TEW-653AP to the same switch/hub.
1.
Run a RJ-45 cable and the power adapter
through the cable clip on the TEW-653AP.
3.
Connect the Power Adapter to the Access Point
and then to a power outlet.
2.
Connect the RJ-45 cable from the Switch/Hub
to the
LAN
port on the Access Point.
4.
Verify that the wireless, LAN and power LEDs
are on.
Page 5 / 18
ENGLISH
FRANÇAIS
DEUTSCH
ESPAÑOL
ÐÓÑÑÊÈÉ
2.
Verify that the wireless, LAN and power LEDs
are on.
Please refer to step 4 in the Hardware
Installation section.
3
3. Power-over-Ethernet Installation
Using the TEW-653AP with a PoE switch
1.
Connect a RJ-45 cable from the Power-Over-
Ethernet Switch (e.g. TRENDnet TPE-80WS) to
the
LAN
port on the Access Point.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top