Page 101 / 128
Scroll up to view Page 96 - 100
z
Edit trap managers
1. Press
<Edit>
key, and then choose the item that you want to modify.
2.
IP:
Type the new IP address
3.
Community Name:
Type the community name.
4. Press
Ctrl +A
go to actions line, press
<Save>
key to save all configure.
z
Delete trap manager
1. Press
<Delete>
key.
2.
Choose the trap manager that you want to delete and then press enter.
3. When pressing
<Enter>
once will complete deletion on delete mode.
- 101 -
Page 102 / 128
4.3.3. GVRP
GVRP (GARP [Generic Attribute Registration Protocol] VLAN Registration Protocol)
GVRP allows automatic VLAN configuration between the switch and nodes.
For example, if the switch is connected to a device with GVRP enabled, you can enable this setting to
allow dynamic VLAN configuration information to be processed by the switch.
If a device sends a GVRP request using the VID of a VLAN defined on the switch, the switch will
automatically add that device to the existing VLAN.
This page you can enable / disable the GVRP (GARP VLAN Registration Protocol) support.
Actions->
1. Select
<Edit>
.
2. Press
Space
key to choose Enabled / Disabled.
3. Press
Ctrl+A
back to action menu line.
4. Select
<Save>
to save configure value.
Note:
GVRP must also be enabled on participating network nodes.
- 102 -
Page 103 / 128
4.3.4. IGMP
The Internet Group Management Protocol (IGMP) is an internal protocol of the Internet Protocol (IP)
suite.
This page you can enable / disable the IGMP support.
Actions->
1. Select
<Edit>
.
2.
IGMP Protocol:
Press
Space
key to choose Enable / Disable.
3.
IGMP Query Mode:
Press
Space
key to choose Auto / Enable /Disable.
4. Press
Ctrl+A
go back action menu line.
5. Select
<Save>
to save configure value.
- 103 -
Page 104 / 128
4.3.5. LACP (Link Aggregation Control Protocol)
This page can configure and view all the LACP status.
Note:
All ports support LACP dynamic trunk group. If connecting to the device that also supports
LACP, the LACP dynamic trunk group will be created automatically.
4.3.5.1. Working Port Setting
This page can set the actually work ports in trunk group.
- 104 -
Page 105 / 128
Actions->
1. Select
<Edit>
.
2.
Group:
Display the trunk group ID.
3.
LACP:
Display the trunk group’s LACP status.
4.
LACP Work Port Num:
The max number of ports can be aggregated at the same time. If LACP
static trunk group, the exceed ports is standby and able to aggregate if work ports fail. If local
static trunk group, the number must be the same as group ports.
NOTE:
Before set this page, you have to set trunk group on the page of
Trunk Configuration
first.
4.3.5.2. State Activity
Actions->
1. Select
<Edit>
.
2. Press
Space
key to choose the item.
Active:
The port automatically sends LACP protocol packets.
Passive:
The port does not automatically send LACP protocol packets, and responds only if it
receives LACP protocol packets from the opposite device.
3. Press
Ctrl+A
go back action menu line.
4. Select
<Save>
to save configure value.
NOTE:
If user set LACP mode in the trunk group, all of the member ports of this trunk group will set
"Active" automatic.
- 105 -
19216811.live