Page 56 / 61 Scroll up to view Page 51 - 55
NetUSB Printing using Auto-Connect Printer
After the driver is installed, you can see a newly created printer in the Control Panel.
Follow the steps below to perform NetUSB printing.
In the Control Center, click the MFP server that has the desired printer (or
MFP) attached.
Click the desired printer (or MFP).
Click the “Auto Connect Printer” button and choose “Set Auto
-Connect
Prin
ter”. The following figure will appear.
Choose the desired printer. The desired printer must be the Windows printer
(this is a logical printer) that matches the printer attached on the MFP server
(this is a physical printer). Then click the “
Apply
button.
Then, the printer will be marked as an “Auto
-
Connected Printer” in red. If you
choose “Auto
-
Connected Printer List” in the “Tools” menu, you can see a newly
created item that describes the association between the Windows printer and
the physical printer on the server.
Then try to issue a print job to the desired printer. You will see the Control
Center will automatically do a connect operation and, once the print job
finished, it will hold the connection. However, the connection will be released
immediately when another user do the printing afterward. At the same time,
the printer is automatically disconnected with your PC.
Page 57 / 61
When you do a print job again. The control center will automatically do a
connecting operation on printing again. This is so-c
alled “Auto Connect /
Disconnect” operation.
Note
:
Under the “Auto
-
Connected Printer” setting, it is
not necessary to manually press
the “
Connect
” button when printing. If you press the “Connect” button for printing,
please make sure to
click “
Disconnect
button after you finish the printing. Otherwise,
other users cannot print properly. It is because you are the only ownership of the
connected printer.
AutoRun
You can make the Control Center be run automatically after you login Windows. To do
this, you cho
ose the “Configuration” item in the “Tools” menu. The followi
ng window will
appear. Click
the check box and then on the “OK” button. This feature is enabled by
default.
Page 58 / 61
NetUSB Scanning using Network Scanning
In the Control Center, click the MFP server that has the desired MFP attached.
Click the desired MFP.
Click the “Network Scanner” button.
Then you can see that the Control Center will automatically do a “connect”
operation. The following window will appear.
Choose one of TWAIN or WIA item.
Click “OK”. The following window will
appear.
Page 59 / 61
Follow the usual steps to do scanning.
Page 60 / 61
Addendum B: Declaration of Conformity

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top