Current Time

: The current time of the specified time zone. You can set the current time

by yourself or configure by NTP server.

NTP server

: The IP address or the host name of the NTP server. You can select from the

list or set it manually.

Time Zone Select

: Select the time zone of the country you are currently in. The router

will set its time based on your selection.

When you finish, click ‘Save’.

so the settings will take effect after it reboots.

Firmware Upgrade

Enable Automatic firmware update

: When enabled the router will check for updates

on the firmware if an updated firmware has been released the router will inform you that

a newer firmware is available and offers to download and install the firmware.

This page also allows you to manually upgrade the firmware for the router. Click the

“Browse” button to select the firmware file and click

the

“Up

grade Firmware

” button to

start upgrading.

IMPORTANT! Do not turn off your router while this procedure is in progress.

Reboot

Whenever you use the Web configuration to change system settings, the changes are

initially placed in temporary storage. To save your change for future use, you have to

click “Apply” to reboot the router. If you have encountered problems

during the

configuration, you can click the “OPS” button in the top panel of the router over 15

seconds to reset default settings.

Addendum A: USB Port Control Center

The netUSB functionality of your router requires additional software to work with your

computer. The following section will describe how the software can be installed and used.

Windows

Insert the CD-ROM that was included with your router and select install utility from the

cd-menu.

The software will inform you about what will be installed.

Click

Next

to continue the installation.

Enter your username and organization if applicable and click

Next

to continue.

Choose a folder where the software should be installed or keep it to default and click

Next

to continue.