Page 36 / 144 Scroll up to view Page 31 - 35
ADSL Router User Manual
Remember to unplug the USB cable before continue the uninstallation, or you will see the
reminder as follows. Unplug and press
OK
.
t
When the
Confirm Device Uninstall
screen show up, check
Delete the driver software
for the device
and click
OK
to continue.
u
Wait while the system is uninstalling.
v
When the uninstallation is finished, the icon of this router under network adapter list will
disappear.
Method Two –
uninstall from program list
28
Page 37 / 144
Chapter 3: Configuration
Note:
If your USB driver is installed by UPnP device, you can only use method one (via the
Device
Manager
) to uninstall, because the installed driver will not be shown on the program list.
n
Unplug your USB cable between your router and your PC.
o
Choose
Start
menu, and open
Control Panel
folder. Click
Uninstall a program
.
p
If the driver name is not on the list, click
Refresh
button or
F5
to update the information.
To remove the driver, select it, and then press
Uninstall
.
Refresh button
q
Then the system will start to uninstall the USB driver software automatically.
r
When Maintenance Complete window shows up, click
Finish
to exit.
29
Page 38 / 144
ADSL Router User Manual
s
The USB driver is successfully removed now
.
Setting TCP/IP
In order to access the Internet through the router, each host on your network must
install/setup TCP/IP. Please follow the steps below for select a network adapter.
30
Page 39 / 144
Chapter 3: Configuration
For Windows 98
1.
Click on the
Start
menu, point
to
Settings
and click on
Control Panel
.
2.
Double-click the
Network
icon
3.
The
Network
window appears. On the
Configuration
tab, check out the list of
installed network components.
Option 1:
If you have
no
TCP/IP
protocol, click
Add
.
Option 2:
If you have TCP/IP protocol,
go to Step 6
Your network
interface card.
Check out if TCP/IP
for your NIC is
installed or not.
4.
Highlight
Protocol
and click
Add
.
31
Page 40 / 144
ADSL Router User Manual
5.
On the left side of the windows,
highlight
Microsoft
and then select
TCP/IP
on the right side. Then click
OK
6.
When returning to
Network
window,
highlight
TCP/IP
protocol for your NIC
and click
Properties
.
7.
On
IP Address
tab:
Enable
Specify an IP address
option.
Enter the
IP Address
: 192.168.1.x (x is
between 2 and 254) and
Subnet Mask
:
255.255.255.0 as in figure below. On
Gateway
tab: Add a gateway IP address:
192.168.1.1 and click OK
32

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top