Page 16 / 202
Scroll up to view Page 11 - 15
1 - Introduction
Page 1-6
SAGEM F@st™ 1704 Reference Manual - 253272861-A
Sagem Communications SAS
document. Reproduction and disclosure prohibited
Page 17 / 202
SAGEM F@st™ 1704 Reference Manual - 253272861-A
Page 2-1
Sagem Communications SAS
document. Reproduction and disclosure prohibited
2.
Description and connection
of router
This section covers
¾
the description of your router
§ 2.1
¾
connecting the ports of your router
§ 2.2
¾
installing your router
§ 2.3
¾
installation safety instructions
§ 2.4
Page 18 / 202
2 - Description and connection of router
Page 2-2
SAGEM F@st™ 1704 Reference Manual - 253272861-A
Sagem Communications SAS
document. Reproduction and disclosure prohibited
2.1
Description
Figure 2.1 gives an overview of a router SAGEM F@st
TM
1704.
Figure 2.1 - Overview of case
This case consists principally of a lid and a base. Inside is a printed circuit equipped with
electronic components.
The front face of the lid has eight display LEDs (see § 2.1.2).
The base has the LED ideograms and the manufacturer logo.
Below the base is a label on which the product's identification code, series number and barcode
are shown.
Page 19 / 202
2 - Description and connection of your router
SAGEM F@st™ 1704 Reference Manual - 253272861-A
Page
2-3
Sagem Communications SAS
document. Reproduction and disclosure prohibited
2.1.1
Connectors
Marking
Meaning
LINE
RJ11 connector - 6 pts. This connector is identified by the colour grey.
It is used for the connection to an ADSL line (WAN interface).
LAN
x
(
1
to
4
)
RJ45 connectors - 8 pts (10/100BASE-T Ethernet Interface). These connectors are
identified by the colour yellow.
They are used to connect to a computer or a television set (via a TV/Video Decoder).
Power
Miniature jack fixed connector.
This connector enables the router to be supplied with direct current from a mains
adapter unit.
Reset
This button allows the router to be reset to the factory configuration (see § A.7).
Note:
To prevent an accidental loss of configuration, the router is reset relative to the
other elements.
WLAN/WPS
This button allows the router to switch to easy-pairing mode.
Page 20 / 202
2 - Description and connection of router
Page 2-4
SAGEM F@st™ 1704 Reference Manual - 253272861-A
Sagem Communications SAS
document. Reproduction and disclosure prohibited
2.1.2
LEDs
The following table describes the meaning of the LEDs on the front panel of the router:
LED
Status
Meaning
Off
Power Off
Green
Power On
Power
Red
Router in rescue mode
Off
ADSL Down
Green steady
ADSL Up
ADSL
Green blinking
ADSL Synchronisation in progress
Off
•
Power Off
or
•
•
The Internet account must be configured
Green steady
•
The Internet account is configured
or
•
Bridge mode
Green blinking
Tx/Rx traffic
Internet
Red
Invalid or unauthorised Internet account
Off
No link detected on the Ethernet port
Green steady
Ethernet port has detected a link with 100 Mbps device
LAN
x
(
1
to
4
)
Green blinking
Tx/Rx traffic at 100 Mbps
Off
Wi-Fi deactivated
Green steady
WI-Fi activated
WLAN
Green blinking
Wi-Fi Tx/Rx
19216811.live