Page 16 / 216
Scroll up to view Page 11 - 15
Administrator’s Handbook
16
Battery Installation (optional)
The optional backup battery is located in a compartment on the bottom of the unit. Installing the battery door
requires some care.
☛
CAUTION
–
The battery used in this device may present a risk of fire or chemical burn if mis-
treated. Do not disassemble, heat above manufacturer’s maximum temperature
limit, or incinerate. Replace battery with Motorola P/N 586185-001-00 only. Use of
another battery may present a risk of fire or explosion.
Dispose of used battery promptly. Keep away from children. Do not disassemble
and do not dispose of in fire.
1.
Note the tab on the bottom of the battery.
2.
Insert the battery into the compartment on the bottom of the unit, as shown, and
press into place so that the battery contacts seat securely in the unit.
3.
Then attach the compartment door. See
“
Battery Door Installation Instructions
” on
page
17
.
Page 17 / 216
17
Battery Door Installation Instructions
1.
Place NVG589 Unit on a table top as shown in FIGURE (1).
2.
Place battery door at an angle, as shown, and slide toward edge of unit.
See FIGURE (2).
3.
Rotate door in direction shown, see FIGURE (3), and snap closed.
4.
Battery door installed. See FIGURE (4).
Page 18 / 216
Administrator’s Handbook
18
Battery Door Removal Instructions
1.
Place unit on table top as shown in FIGURE (1).
2.
Using both hands, pull tabs in directions shown in FIGURE (2).
3.
While still pulling the tabs, pull the battery door in the direction shown.
See FIGURE (3).
4.
Remove battery door. See FIGURE (4).
Page 19 / 216
19
Cradle Installation Instructions
1.
Angle the NVG589 unit onto the rear of the cradle. See FIGURE (1).
2.
Ensure that the NVG589 unit is latched to the rear of the cradle as shown in
FIGURE (2).
3.
Once the rear is latched, rotate the NVG589 unit down into the cradle and press until
the snap is engaged. You should hear a “click” for positive engagement.
See FIGURE (3).
4.
Reverse sequence, by first pulling on the cradle, for removal.
Page 20 / 216
Administrator’s Handbook
20
Set up the Motorola Gateway
Refer to your Quickstart Guide for instructions on how to connect your Motorola
®
gateway to your power source,
PC or local area network, and your Internet access point, whether it is a dedicated DSL outlet or a DSL or cable
modem. Different Motorola
®
Gateway models are supplied for any of these connections. Be sure to enable
Dynamic Addressing on your PC. Perform the following:
Microsoft Windows:
Step 1. Navigate to the TCP/IP Properties Control Panel.
a
. Some Windows versions follow a path like this:
Start
menu ->
Settings
->
Control Panel
->
Network
(or
Network
and Dial-up Connections
->
Local Area Connection
->
Proper-
ties
) ->
TCP/IP [your_network_card]
or
Internet Protocol
[TCP/IP]
->
Properties
b
.
Some Windows versions follow a path like this:
Start
menu ->
Control Panel
->
Network and Internet
Connections
->
Network Connections
->
Local Area
Connection
->
Properties
->
Internet Protocol [TCP/IP]
->
Properties
Then go to Step 2.
Step 2. Select Obtain an IP address automatically.
Step 3. Select Obtain DNS server address automatically, if available.
Step 4. Remove any previously configured Gateways, if available.
Step 5. OK the settings. Restart if prompted.
19216811.live