X5671

User’s Guide

71

A2.

Software Specifications



Bridging



Transparent Bridging and spanning(IEEE 802.1D) with at least 32 MAC

addresses



RFC2684 (RFC 1483) Bridged



Bridge filtering with per-port extensions



Routing



IP routing and PPP supported



PAP and CHAP for user authentication in PPP connection



RFC2684 (RFC1483) Routed



MAC Encapsulated Routing (MER)



DHCP client, server and relay agent



DNS relay



Wireless LAN



Supports 802.1x; WEP; WEP2; WPA; WPA2; TKIP; AES;



Hidden SSID



WMM for advanced Quality of Service



Supports TKIP and AES



Firewall



Support NAT and DMZ



Protection against IP and MAC address spoofing



UPnP NAT traversal and VPN / IPSec pass-through



Configuration and Network Management Features



DHCP client and server for IP management



UPnP Internet Gateway Device (IGD) compliance



WEB for local or remote management



HTTP for firmware upgrade and configuration



Embedded syslog



Support TR-069 with parameters: DeviceInfo, ManagementServer, Time,

IPPingDiagonostic, etc

Note:

The hardware and software specifications are subjected to change without notices.

X5671

User’s Guide

72

Appendix E - Warranties

B1.

Product Warranty

Inteno Broadband Technology AB warrants that the xDSL unit will be free from defects in

material and workmanship for a period of twelve (12) months from the date of shipment.

Inteno Broadband Technology AB shall incur no liability under this warranty if

The allegedly defective goods are not returned prepaid to Inteno Broadband

Technology AB within thirty (30) days of the discovery of the alleged defect and in

accordance with Inteno Broadband Technology AB’ repair procedures; or

Inteno Broadband Technology AB’ tests disclose that the alleged defect is not due to

defects in material or workmanship.

Inteno Broadband Technology AB’ liability shall be limited to either repair or replacement

of the defective goods, at Inteno Broadband Technology AB’ option.

Inteno Broadband Technology AB MARKS NO EXPRESS OR IMPLIED WARRANTIES

REGARDING

THE

QUALITY,

MERCHANTABILITY,

OR

FITNESS

FOR

A

PARTICULAR PURPOSE BEYOND THOSE THAT APPEAR IN THE APPLICABLE

USER’S

DOCUMETATION.

INTENO

SHALL

NOT

BE

RESPONSIBLE

FOR

CONSEQUENTIAL, INCIDENTAL, OR PUNITIVE DAMAGE, INCLUDING, BUT NOT

LIMITED TO, LOSS OF PROFITS OR DAMAGES TO BUSINESS OR BUSINESS

RELATIONS. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES.

X5671

User’s Guide

73

B2.

Warranty Repair

1.

During the first three (3) months of ownership, Inteno Broadband Technology AB will

repair or replace a defective product covered under warranty within twenty-four (24)

hours of receipt of the product. During the fourth (4th) through twelfth (12th) months

of ownership, Inteno Broadband Technology AB will repair or replace a defective

product covered under warranty within ten (10) days of receipt of the product. The

warranty period for the replaced products shall be ninety (90) days or the remainder

of the warranty period of the original unit, whichever is greater. Inteno Broadband

Technology AB will ship surface freight. Expedited freight is at customer’s expense.

2.

The customer must return the defective product to Inteno Broadband Technology AB

within fourteen (14) days after the request for replacement. If the defective product is

not returned within this time period, Inteno Broadband Technology AB will bill the

customer for the product at list price.

B3.

Out-of-Warranty Repair

Inteno Broadband Technology AB will either repair or, at its option, replace a defective

product not covered under warranty within ten (10) working days of its receipt. Repair

charges are available from the Repair Facility upon request. The warranty on a

serviced product is thirty (30) days measured from date of service. Out-of-warranty

repair charges are based upon the prices in effect at the time of return.

X5671

User’s Guide

74

Appendix F - Regulation

FCC Part 15 Notice

Warning:

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 to the FCC rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment is

operated in a residential environment. This equipment generates, used, and can

radiate radio frequency energy, and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is unlikely to cause harmful

interference. But if it does, the user will be required to correct the interference at his or

her own expense. The authority to operate this equipment is conditioned by the

requirement that no modifications will be made to the equipment unless Inteno

expressly approves the changes or modifications.

FCC Part 15 Notice with Wireless

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user‘s authority to operate the equipment.

The antenna(s) used for this transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

Warning:

Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received including interference that may cause

undesired operation.

X5671

User’s Guide

75

FCC Part 68 Notice

This equipment complies with Part 68 of FCC Rules. On the base unit of this

equipment is a label that contains, among other information, the FCC Registration

Number and Ringer Equivalence Number (REN) for this equipment. IF REQUESTED,

THIS INFORMATION MUST BE GIVEN TO THE TELEPHONE COMPANY.

The REN is useful to determine the quantity of devices you may connect to your

telephone line and still have all of those devices ring when your telephone number is

called. In most, but not all areas, the sum of the REN of all devices connected to one

line should not exceed five (5.0). To be certain of the number of devices you may

connect to you line, as determined by the REN, you should contact your local

telephone company to determine the maximum REN for your calling area.

If your equipment causes harm to the telephone network, the telephone company may

discontinue your service temporarily. If possible, they will notify you in advance. But if

advance notice is not practical, you will be notified as soon as possible. You will be

informed of your right to file a complaint with the FCC. Your telephone company may

make changes in it is facilities, equipment, operations or procedures that could affect

the proper functioning of your equipment. If they do, you will be notified in advance to

give you an opportunity to maintain uninterrupted telephone service.

If you experience trouble with this telephone equipment, Please contact the following

address and phone number for information on obtaining service or repairs.

The telephone company may ask that you disconnect this equipment from the

network until the problem has been corrected or until you are sure that the equipment

is not malfunctioning.

This equipment may not be used on coin service provided by the telephone company.

Connection to party lines is subject to state tariffs.

NOTICE: The Telephone Consumer Protection Act of 1991 makes it unlawful for any

person to use a computer or an electronic device to send any message via a

telephone fax machine, unless such a message clearly contains in a margin at the top

or bottom of each transmitted page or on the first page of the transmission the

following information:



The date and time of transmission



Identification of either business, business entity or individual sending message



Telephone number of either the sending machine, business entity or individual

Warning:

Users should not attempt to make such connections themselves, but should

contact appropriate electric inspection authority, or electrician, as appropriate.

Do not use any other power adapter except the one that accompanies the unit. Use of

other adapter could result in damage to the unit. To prevent electronic shock, please do not

open the cover.