Page 31 / 109
Scroll up to view Page 26 - 30
21
z
Configured MTU
: Enter the maximum bytes of the packet
being transmitted during connection.
III.
DHCP
The setting page displayed as below will appear if you select
DHCP mode, which means automatically acquire IP address from
the DHCP sever of ISP.
Figure 4-5
RFC2684 Bridged Connection-application of DHCP
z
Default Route:
This setting specified the IP address below
is used for default route of LAN. The data will be sent
Page 32 / 109
22
through WAN interface whenever a client LAN computer
accesses the Internet.
z
Gateway IP address:
Enter the Gateway address
provided by ISP.
z
Traffic Index:
Select the index number for ATM traffic from
the pull-down menu.
z
Configured MTU
: Enter the maximum bytes of the packet
being transmitted during connection.
IV.
Save
z
Click the
Submit
button to save the settings in the RAM.
z
To save these configuration changes permanently, enter
the
Save & Reboot
page, select
Save
and click
Submit
button to save new settings.
Page 33 / 109
23
4.3.2
RFC2684 Route (IPoA) Configuration
I.
Configuration page
Figure 4-6
RFC2684 route (IPoA) configuration
II.
Parameters explanation
z
PVC:
The system provides 8 PVCs. Generally you can
leave this set at the default value 0. This option is also used
to create and configure new PVCs.
z
VPI:
If you need any modification, please enter the VPI
value provided by ISP. See the attached table for all the
VPI default values of PVCs.
Page 34 / 109
24
z
VCI:
If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default values of PVCs.
z
Operation Mode:
This also should be left at the default
setting
Enabled
. This enables the PVC used for the initial
connection.
z
Encapsulation:
You can select the mode LLC or VC MUX.
z
IP Address
and
Subnet Mask:
Enter the IP address and
subnet mask provided by ISP for the WAN interface of your
MT800.
z
Default Route:
This setting specified the IP address below
is using for default route of LAN. The data will be sent
through WAN interface whenever a client LAN computer
accesses the Internet.
z
Gateway IP address:
Enter the Gateway address
provided by ISP.
z
Traffic Index:
Select the index number for ATM traffic from
the pull-down menu.
z
Configured MTU
: Enter the maximum bytes of the packet
being transmitted during connection.
III.
Save
z
Click the
Submit
button to save the settings in the RAM.
z
To save these configuration changes permanently, enter
the
Save & Reboot
page, select
Save
and click
Submit
button to save new settings.
4.3.3
PPP Configuration
There are two options for PPP configuration: PPPoA and
PPPoE.
Page 35 / 109
25
I.
PPPoA
Figure 4-7
PPP configuration-PPPoA
z
PVC:
System provides 8 PVCs. Generally you can leave
this set at the default value 0. This option is also used to
create and configure new PVCs.
z
VPI:
If you need any modification, please enter the VPI
value provided by ISP. See the attached table for all the
VPI default value of PVC.
19216811.live