19216811.live5
3 Setting Up a Wireless Connection
If a wireless network adapter is installed on your computer, you can connect
your computer to the HG658 over a wireless connection.
The method for installing the wireless adapter and its driver varies
by vendor. For details, see the installation guide provided by the
vendor of your wireless adapter.
The wireless network function is enabled on the HG658 before delivery. To
check the function status, see section 5.3 "Enabling or Disabling the Wireless
Network Function".
There are two methods for setting up a wireless connection between the
HG658 and your computer.
3.1 Setting up a Wireless Connection Using the
WPS Button
The HG658 supports the Wi-Fi Protected Setup (WPS) function in Push Button
Configuration (PBC) mode. If your wireless network adapter also supports the
WPS function, do the following to connect your computer to the HG658 over
a wireless connection:
Step 1
Press and hold the
WPS
button (on the HG658 side panel) for 1 or
more seconds.
The
WLAN
indicator light on the HG658 starts blinking, indicating that
the HG658 is in the WPS negotiation state.
Step 2
Enable the WPS negotiation function on the computer within 2
minutes of the previous step.
Wait until the HG658
WLAN
indicator light stops blinking and remains
steady on. This indicates that a wireless connection is set up between
the HG658 and the computer.