Page 106 / 138
Scroll up to view Page 101 - 105
97
There is only one option in this page, please select ‘Enable’ or ‘Disable’
to enable or disable UPnP function, then click ‘Apply’ button, and the
following message will be displayed on your web browser:
Please click ‘Continue’ to go back to previous setup menu; to continue on
other setup procedures, or click ‘Apply’ to reboot the router so the
settings will take effect (Please wait for about 30 seconds while router is
rebooting).
If you want to reset all settings in this page back to previously-saved
value, please click ‘Cancel’ button.
Page 107 / 138
98
3-2-6 ALG Settings
Application Layer Gateway (ALG) is a special function of this router. It
includes many preset routing rules for numerous applications which
require special support. With these supports, those applications which
required special support will be able to work with NAT architecture.
Please click ‘Apps and Gaming’ tab at the top of web management
interface, then click ‘ALG Settings’, and the following message will be
displayed on your web browser:
There are many applications listed here. Please check the box of the
special support for applications you need, and then click ‘Apply’ button
and the following message will be displayed on your web browser:
Page 108 / 138
99
Please click ‘Continue’ to go back to previous setup menu; to continue on
other setup procedures, or click ‘Apply’ to reboot the router so the
settings will take effect (Please wait for about 30 seconds while router is
rebooting).
If you want to reset all settings in this page back to previously-saved
value, please click ‘Cancel’ button.
Page 109 / 138
100
3-3
Firewall
Besides NAT, this router also provides firewall function to block
malicious intruders from accessing your computers on local network.
These functions include inbound attack prevention, and block outbound
traffics, like block URLs which have pre-defined keywords.
Please follow instructions to enable or disable firewall function:
Please click ‘Security’ tab at top of web management interface, and the
following message will be displayed on your web browser:
Please select ‘Enable’ or ‘Disable’ to enable or disable firewall function
of this router, the click ‘Apply’ button, and the following message will be
displayed on your web browser:
Please click ‘Continue’ to go back to previous setup menu; to continue on
other setup procedures, or click ‘Apply’ to reboot the router so the
settings will take effect (Please wait for about 30 seconds while router is
rebooting).
3-3-1 Access Control
This function allows or denies computers with specific MAC address
Page 110 / 138
101
from connecting to the network; it can also allow or deny computers with
specific IP address, protocol, or port.
Please click ‘Security’ tab at the top of web management interface, then
click ‘Access Control’, and the following message will be displayed on
your web browser:
Here are descriptions of every setup items:
Enable MAC
Check this box to enable MAC address based
Filtering (1):
filtering, and please select ‘Deny’ or ‘Allow’ to
decide the behavior of MAC filtering table. If you
select deny, all MAC addresses listed in filtering
table will be denied from connecting to the network;
if you select allow, only MAC addresses listed in
filtering table will be able to connect to the network,
and rejecting all other network devices.
Client PC
Please input the MAC address of computer
MAC address (2):
or network device here, dash ( - ) or colon ( : ) are
not required. (i.e. If the MAC address label of your
1
2
3
5
6
7
8
9
10
12
13
14
15
16
11
4
19216811.live