1. Home
    2. /
  2. Manuals
    3. /
  3. Hawking
    4. /
  4. HW2R1
    5. /
  5. 6
Page 26 / 134 Scroll up to view Page 21 - 25
18
Input ‘ipconfig’, then press ‘Enter’ key. Please check the IP address followed
by ‘Default Gateway’ (In this example, the IP address of Smart Repeater is
192.168.1.200
,
please note that this value may be different.
)
3. Connect the Smart Repeater’s management interface by web browser
After your computer obtained an IP address from Smart Repeater, please start
your web browser, and input the IP address of Smart Repeater in address bar.
The following message should be shown (or you may type
in
to access the quick setup menu):
Please input user name and password in the field respectively, default user
name is ‘admin’, and default password is ‘1234’, then press ‘OK’ button, and
you can see the web management interface of this Smart Repeater.
NOTE: If the IP address of Gateway is not displayed, or the address followed
by ‘IP Address’ begins with ‘169’, please recheck network connection
between your computer and Smart Repeater, and / or go to the beginning of
this chapter, to recheck every step of network setup procedure.
Page 27 / 134
19
2-3 Using ‘Quick Setup’
This Smart Repeater provides a ‘Quick Setup’ procedure, which will help you
to complete all required settings you need to access the Internet in a very short
time. Please follow the following instructions to complete the ‘Quick Setup’:
Page 28 / 134
20
a. The first step of the ‘Quick Setup’ is to locate a position to place your
Smart Repeater.
The position should be a location where the
Repeater can pick up the signal that you wish to repeat (i.e. the
neighbor’s wireless connection, local hot spot, etc.).
b. Click Scan to locate all the networks within your area.
Once you have
found the network you wish to repeat, highlight it and click Next.
Each
wireless network will be listed with their respective signal strengths and
whether or not they are using security.
For secure networks, you will
need to have the correct key to access the network.
If you do not you
will not be able to repeat this network.
It is recommended that the
signal strength of the network you are trying to repeat is above 50% to
ensure a solid connection to the Internet.
Without a stable Internet
connection, the rebroadcasted signal will be unstable as well.
c.
The ‘Quick Setup’ wizard will now attempt to connect to your wireless
Internet connection.
Select “Automatic Setup” to have the wizard automatically configure the
IP settings of your Internet Connection.
Most networks use Dynamic
IP settings to automatically assign IP Addresses to incoming
connections.
If the network you are connecting does not use Dynamic
IP settings you will need to manually configure (Manual Setup) your IP
settings.
Page 29 / 134
21
d. If a wireless security key is necessary, the wizard will prompt you to
enter the key.
This key pertains to WEP and WPA wireless security
keys and passphrases.
Page 30 / 134
22
e. When the connection has been established the wizard will prompt you if
you wish to adjust the name of the wireless network used within your
home (a.k.a. the SSID of the network that users will be connecting to
from within your home – the redistributed wireless network).
In
addition, if you would like to add wireless security to your home wireless
network you may do so here as well.
f.
Click FINISH to complete your setup.
Then press Apply to initiate the
reboot of your Smart Repeater.

Rate

4.5 / 5 based on 2 votes.

Popular Hawking Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top