Page 71 / 97
Scroll up to view Page 66 - 70
66
In this page, you can configure universal plug and play
(UPnP). The system acts as a daemon after you enable
UPnP.
UPnP is used for popular audio / video software. It allows
automatic discovery of your device in the network. If you are
concerned about UPnP security, you can disable it. Block
ICMP ping should be enabled so that the device will not
respond malicious Internet requests.
Click
Apply
to save the settings.
3.3.10.5 ADSL Settings
Choose
ADVANCED
>
Network Tools
and click
ADSL
Settings
. The page shown in the following figure appears.
In this page, you can select the DSL modulation. Normally,
you can keep factory default setting.
Page 72 / 97
67
The AR-7284WnA supports AnnexA mode, so the AnnexB is
not enabled.
Click
Apply
to save the settings.
Page 73 / 97
68
3.3.10.6 SNMP
Choose
ADVANCED
>
Network Tools
and click
SNMP
. The
page shown in the following figure appears.
In this page, you
can set SNMP parameters.
°
Read Community
: The network administrator must use
this password to read the information of this device.
°
Set Community
: The network administrator must use
this password to configure the information of this device.
°
Trap Manager IP
: The trap information is sent to this
host.
Click
Apply
to save the settings.
Page 74 / 97
69
3.3.10.7 TR069
Choose
ADVANCED
>
Network Tools
and click
TR-069
. The
page shown in the following figure appears.
In this page, you
can configure the TR069 CPE.
Click
Apply
to save settings.
Page 75 / 97
70
3.3.10.8 Certificates
Choose
ADVANCED
>
Network Tools
and click
Certificates
.
The
Certificates
page shown in the following figure appears.
In the
Certificates
page, click
Trusted CA
. The page shown
in the following figure appears.
Click
Input Certificate
, the page shown in the following figure
appears.
19216811.live