Page 76 / 97
Scroll up to view Page 71 - 75
71
Click
Apply
to save the settings.
Page 77 / 97
72
3.3.11
Routing
Choose
ADVANCED
>
Routing
. The page shown in the
following page appears.
3.3.11.1 Static Route
Choose
ADVANCED
>
Routing
and click
Static Route
. The
page shown in the following figure appears. This page is used
to configure the routing information. In this page, you can add
or delete IP routes.
Page 78 / 97
73
Click
Add
to add a static route. The page shown in the
following figure appears.
°
Destination Network Address
: The destination network
address.
°
Subnet Mask
: The subnet mask of the destination
network.
°
Use Gateway IP Address
: The gateway IP address of
the destination network.
°
User Interface
: The interface name of the router output
port.
You can only choose
Use Gateway IP Address
or
User
Interface
.
Page 79 / 97
74
Click
Apply
to save the settings.
3.3.11.2 Default Gateway
Choose
ADVANCED
>
Routing
and click
Default Gateway
.
The page shown in the following figure appears.
Click
Apply
to save the settings.
Page 80 / 97
75
3.3.11.3 RIP Settings
Choose
ADVANCED
>
Routing
and click
RIP
Settings
. The
page shown in the following figure appears. This page is used
to select the interfaces on your device that use RIP and the
version of the protocol being used.
If you are using this device as a RIP-enabled device to
communicate with others using the routing information
protocol, enable RIP and click
Apply
to save the settings.
19216811.live