19216811.liveVigor 2820 Series Quick Start Guide
15
2. Installing Your Router
This section will guide you to install the router through hardware connection and
configure the router’s settings through web browser.
2.1 Hardware Installation
Before starting to configure the router, you have to connect your devices correctly.
1.
Connect the ADSL interface to the external ADSL splitter with an ADSL line cable
for all models. For Vigor2820V/Vn/VS/VSn, also connect Line interface to external
ADSL splitter.
For second WAN, connect the cable Modem/DSL Modem/Media Converter to
WAN2 port of router with Ethernet cable (RJ-45).
2.
Connect one end of an Ethernet cable (RJ-45) to one of the
LAN
ports of the router
and the other end of the cable (RJ-45) into the Ethernet port on your computer.
3.
Connect the telephone sets with phone lines (for using VoIP function). For the model
without phone ports, skip this step.
4.
Connect one end of the power adapter to the router’s power port on the rear panel,
and the other side into a wall outlet.
5.
Power on the device by pressing down the power switch on the rear panel.
6.
The system starts to initiate. After completing the system test, the
ACT
LED will
light up and start blinking.
(For the detailed information of LED status, please refer to section 1.1.)