Page 81 / 103
Scroll up to view Page 76 - 80
DSL-2750E User Manual
78
3.3.18 IP Tunnel
Choose
ADVANCED
>
IP Tunnel
. The page shown in the following figure
appears.
Page 82 / 103
DSL-2750E User Manual
79
3.3.18.1 4in6 Tunnel
Choose
ADVANCED
>
IP Tunnel
and then click
4in6 Tunnel
. The page shown in
the following figure appears. In this page, you can configure IPv4 penetration
through IPv6 network. When only IPv6 access is provided by your ISP, you can
access the Internet via IPv4 and IPv6.
Page 83 / 103
DSL-2750E User Manual
80
Click
Add
below the table
IPTUNNEL
to add tunnel items. The page shown in the
following figure appears.
The following table describes the parameters of this page.
Field
Description
Tunnel Name
Set a tunnel name.
Tunnel Mode
Select the tunnel mode as 4 in6 or 6in4.
Wan Interface
Choose a WAN interface used for the tunnel.
Lan Interface
Choose a LAN interface used for the tunnel.
Click
Apply
to enable the settings.
Click
Add
below the table
DS-Lite IPv4 over IPv6 Tunnel List
to add a DS-Lite
item
，
which is a 4in6 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field
Description
Mechanism
The tunnel type is DS-Lite, which is 4in6 tunnel.
Dynamic
Set the obtaining mode of remote IPv6 addresses.
You can select
0
or
1
.
RemoteIPv6Address
Set the remote end IPv6 address of the tunnel.
Page 84 / 103
DSL-2750E User Manual
81
Click
Apply
to enable the settings.
3.3.18.2 6in4 Tunnel
Choose
ADVANCED
>
IP Tunnel
and then click
6in4 Tunnel
. The page shown in
the following figure appears.
In this page,
you can configure IPv6 penetration
through IPv4 network. When only IPv4 access is provided by your ISP, you can
access the Internet via IPv4 and IPv6.
Click
Add
below the table
IPTUNNEL
to add tunnel items. The page shown in the
following figure appears.
The following table describes the parameters of this page.
Field
Description
Tunnel Name
Set a tunnel name.
Tunnel Mode
Select the tunnel mode as 4 in6 or 6in4.
Page 85 / 103
DSL-2750E User Manual
82
Wan Interface
Choose a WAN interface used for the tunnel.
Lan Interface
Choose a LAN interface used for the tunnel.
Click
Apply
to enable the settings.
Click
Add
below the table
IPv6 Rapid Deployment
to add a 6RD item, which is a
6in4 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field
Description
Mechanism
The tunnel type is 6RD, which is a 6in4 tunnel.
Dynamic
Set the obtaining mode of Border Relay Address. You
may choose
0
or
1
.
IPv4MaskLen
Set the subnet mask digits of the IPv4 address of the
local WAN interface.
Prefix
Set the IPv6 prefix of the 6RD tunnel.
BorderRelayAddress
Set the Border Relay IPv4 address at the remote end.
Click
Apply
to enable the settings.
3.3.19 Logout
Choose
ADVANCED
>
Logout
. The page shown in the following figure appears.
In this page, you can log out of the configuration page.
19216811.live