Page 71 / 103
Scroll up to view Page 66 - 70
DSL-2750E User Manual
68
In this page, you can configure universal plug and play (UPnP). The system acts
as a daemon after you enable UPnP.
UPnP is used for popular audio visual software. It allows automatic discovery of
your device in the network. If you are concerned about UPnP security, you can
disable it. Block ICMP ping should be enabled so that the device does not
respond to malicious Internet requests.
Click
Apply
to save the settings.
3.3.12.6
ADSL
Choose
ADVANCED
>
Network Tools
and click
ADSL
. The page shown in the
following figure appears.
Page 72 / 103
DSL-2750E User Manual
69
In this page, you can select the DSL modulation. Normally, you can remain this
factory default setting. The device negotiates the modulation mode with DSLAM.
Click
Apply
to save the settings.
3.3.12.7 SNMP
Choose
ADVANCED
>
Network Tools
and click
SNMP
. The page shown in the
following figure appears. In this page, you can set SNMP parameters.
Page 73 / 103
DSL-2750E User Manual
70
3.3.13 Routing
Choose
ADVANCED
>
Routing
. The page shown in the following page appears.
3.3.13.1
Static Route
Choose
ADVANCED
>
Routing
and click
Static Route
. The page shown in the
following figure appears. This page is used to configure the routing information.
In this page, you can add or delete IP routes.
Page 74 / 103
DSL-2750E User Manual
71
Click
Add
to add a static route. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field
Description
Destination
Network
Address
The destination IP address of the router.
Subnet Mask
The subnet mask of the destination IP
Use Interface
The interface name of the router output port.
Click
Apply
to save the settings.
3.3.13.2 IPv6 Static Route
Choose
ADVANCED
>
Routing
and click
IPv6 Static Route
. The page shown in
the following figure appears. This page is used to configure the routing
information. In this page, you can add or delete IP routes.
Click
Add
to add a static route. The page shown in the following figure appears.
Page 75 / 103
DSL-2750E User Manual
72
The following table describes the parameters of this page.
Field
Description
Destination
Network Address
The destination IPv6 address of the router.
Use Interface
The interface name of the router output port.
Click
Apply
to save the settings.
3.3.13.3 Policy Route
Choose
ADVANCED
>
Routing
and click
IPv6 Static Route
. The page shown in
the following figure appears. The policy route binds one WAN connection and
one LAN interface.
Click
add
, the page shown in the following figure appears.
19216811.live