Page 16 / 154
Scroll up to view Page 11 - 15
11
Power ON Self-Test
Every DP-G310 has been factory-tested to operate properly.
When the DP-G310 is powered ON, it also automatically performs a Self-Test on
each of its major components. The final result of the Self-Test is signaled by the
state of the USB LED indicator following the Self-Test. Preliminary to the actual
component tests, the four LED indicators are tested to confirm their steady and
flashing operation.
Immediately after power-up, all four of the green LEDs should illuminate steadily for
several seconds. Then the USB LED should light OFF. Irregularity of any of the four
LEDs during these LED tests may mean there is a problem with the LEDs
themselves.
The actual component tests immediately follow the LED tests. A normal (no fault)
result is signaled by a simultaneous flashing of the USB LED three times, followed
by a quiescent state with the USB LED dark.
If the Self-Test routine traps any component error, then following the LED tests the
Self-Test will halt and the USB LED will continuously signal the error according to
the following table. In the event of any such error signal, contact your dealer for
correction of the faulty unit.
Page 17 / 154
12
USB LED
Faulty Component
On
DRAM error
1 long 3 short
Flash Protected
1 long 5 short
Flash Erase/Program error
1 long 6 short
LAN Controller error
1 long 14 short
LAN MII error
1 long 15 short
WLAN Initial error
1 long 16 short
WLAN Access error
1 long 18 short
USB error
1 long 19 short
PCI error
Page 18 / 154
13
Getting Started
Below is a sample network using the DP-G310. The DP-G310 has a built- in
Web-based management feature that allows users to easily configure and manage
multiple print queues through TCP/IP.
For a list of printers that are compatible with the DP-G310, please see the Appendix
in this manual. The compatibility list is not comprehensive. Even if it is not included
in the list, your printer may be compatible with the DP-G310.
Page 19 / 154
14
Using PS-Wizard
This chapter will introduce you the installation and operation of a useful software
program – PS-Wizard.
Auto-Run Installation
Insert the Installation CD-ROM into your computer’s CD-ROM drive to initiate the
Auto-Run program. The content of the Installation CD-ROM includes:
y
View Quick Installation Guide
- click to preview the
Quick Installation Guide
in
PDF format for step-by-step instructions of the print server Installation.
•
View Manual
– click to preview the
User's Guide
in PDF format for detailed
information of the print server.
•
Install Acrobat Reader
– click to launch Acrobat Reader for the viewing and
printing of PDF files in the Installation CD-ROM.
•
Install PS-Wizard
– click to install
PS-Wizard
to complete further settings for
the print server, such as:
-
Changing IP address
-
Adding a printer on your computer in the easiest way.
•
Close
– click to close the Auto-Run program.
Page 20 / 154
15
PS-Wizard
To avoid the conflict in your network, you can use
PS-Wizard
to change the related
settings of your print server (such as the IP address) after finishing the installation of
PS-Wizard
on your PC.
Installing PS-Wizard
1.
Click the
PSWizardSetup
icon of the Installation CD-ROM, and then the system
will prompt a window for you to select a desired setup language from its
pull-down menu. After done the selection of language, click
OK
button to
continue.
19216811.live