Page 11 / 50
Scroll up to view Page 6 - 10
7
D-Link DCS-1130 User Manual
Section 2 - Installation
Insert the Installation CD-ROM into your computer’s CD-ROM drive to start the autorun program.
The CD-ROM will open the Camera Setup Wizard. Simply click
Start
to go through the Setup Wizard, which will help
you through the entire installation process from connecting your hardware to configuring your camera.
Starting the Camera Setup Wizard
Installation
Page 12 / 50
8
D-Link DCS-1130 User Manual
Section 2 - Installation
Hardware Installation
Attach the Antennas
Screw the wireless antennas onto the antenna connectors.
Connect the Camera to the Camera Base
1. Screw the two camera base pieces together.
2. Screw the camera base into the mounting point on either the back
or the bottom of the camera and tighten the collar.
You can adjust the angle and pivot of the camera by loosening the
wheel and retightening it after moving it to the desired position.
Page 13 / 50
9
D-Link DCS-1130 User Manual
Section 2 - Installation
Connect the Ethernet Cable
Connecting to a router
Connecting to a broadband modem
Connect one end of the blue Ethernet cable included in your package to the Ethernet port on the back of the
DCS-1130 camera. Connect the other end of the cable to an available LAN port on your router or broadband
modem.
Attach the power adapter to the power jack located on the back of the DCS-1130 and
connect the power adapter to a power outlet. After connecting the power adapter, you
should see the status LED on the front of the camera turn on.
The status LED will light red when it receives power, will light green after the camera
connects to the network, and will flash green when the camera is being accessed.
Connect the Power Adapter
Page 14 / 50
10
D-Link DCS-1130 User Manual
Section 2 - Installation
Connecting to a Wireless Network Using WPS
If your router supports WPS connection, you can connect your camera using the WPS button on the camera.
Press and hold the WPS button on the side of the camera for three seconds.
The status LED on the front of the camera will turn blue.
Press the WPS button on your router within 60 seconds. The WPS button is
usually on the front or side of your router. On some routers, you may need to
log in to the web interface and then click on an onscreen button to activate
the WPS feature. If you are not sure where the WPS button is on your router,
please refer to your router’s User Manual.
The DCS-1130 will then automatically create a wireless connection to your
router. While connecting, your camera’s LED will flash and then your camera
will reboot. After rebooting, the status LED on the front of the camera will
turn solid green.
Page 15 / 50
11
D-Link DCS-1130 User Manual
Section 3 - Configuration
Using the Configuration Menu
After completing the Camera Setup Wizard, you are ready to use your camera. The camera’s built-in Web configuration
utility is designed to allow you to easily access and configure your DCS-1130. At the end of the wizard, click
Go To
Camera
, or enter the IP address of your camera into a web browser, such as Internet Explorer
®
. To log in, use the
User name
admin
and the password you created in the Setup Wizard. If you did not create a password, the default
password is blank. After entering your password, click
OK
.
Note
: If you are directly connecting your PC to the camera, or if you are using the camera on a closed network, the
default IP is
192.168.0.20
.
19216811.live