Page 46 / 100 Scroll up to view Page 41 - 45
46
D-Link DAP-1522 User Manual
Section 3 - Configuration
Statistics
The Statistics page displays all of the LAN and Wireless packets transmit and receive statistics.
TX Packets:
RX Packets:
TX Packets
Dropped:
RX Packets
Dropped:
TX Bytes:
RX Bytes:
The total number of packets sent from the access
point.
The total number of packets received by the access
point.
Displays the number of packets that were dropped
while sending, due to errors, collisions, or access
point resource limitations.
Displays the number of packets that were dropped
while receiving, due to errors, collisions, or access
point resource limitations.
Displays the number of bytes that were sent from
the access point.
Displays the number of bytes that were received
by the access point.
Page 47 / 100
47
D-Link DAP-1522 User Manual
Section 3 - Configuration
Help
Page 48 / 100
48
D-Link DAP-1522 User Manual
Section 3 - Configuration
Configuration for Bridge Mode
This section will show you how to configure your new D-Link wireless MediaBridge using the web-based configuration
utility.
Web-based Configuration Utility
To access the configuration utility, open a web-browser
such as Internet Explorer and enter dlinkap or enter
192.168.0.50 in the address field.
Select
Admin
from the drop-down menu and then enter
your password. Leave the password blank by default.
If you get a Page Cannot be Displayed error, please
refer to the Troubleshooting section for assistance.
Page 49 / 100
49
D-Link DAP-1522 User Manual
Section 3 - Configuration
This wizard is designed to assist you in configuring the wireless settings for your bridge. It will guide you through
step-by-step instructions on how to setup your wireless network.
Click Launch Wireless Setup Wizard to begin.
Click Launch Wireless Setup Wizard
Setup Wizard
Enter the Device Name of the AP and click
Next
to
continue. It is recommended to change the Device
Name if there is more than one D-Link device within
the subnet.
Page 50 / 100
50
D-Link DAP-1522 User Manual
Section 3 - Configuration
Select
Auto
configuration if you want to use Wi-Fi
Protected Setup.
If you want to set up your network manually, skip to page
53.
Click
Next
to continue.
If you want to change the admin account password,
enter a new password and click
Next.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top