Page 106 / 134
Scroll up to view Page 101 - 105
DG-BG4100N User
Manual
106
The page shown in the following figure appears.
Page 107 / 134
DG-BG4100N User
Manual
107
The following table describes the parameters and buttons of this page:
Field
Description
IP QoS
Select to enable or disable IP QoS function. You need to
enable IP QoS if you want to configure the parameters of this
page.
QoS Policy
You can choose stream based, 802.1p based, or DSCP based.
Schedule Mode
You can choose strict prior or WFQ (4:3:2:1).
Source IP
The IP address of the source data packet.
Source Mask
The subnet mask of the source IP address.
Destination IP
The IP address of the destination data packet.
Destination Mask
The subnet mask of the destination IP address.
Source Port
The port of the source data packet.
Destination Port
The port of the destination data packet.
Protocol
The protocol responds to the IP QoS rules. You can choose
TCP, UDP, or ICMP.
Phy Port
The LAN interface responds to the IP QoS rules.
Set priority
The priority of the IP QoS rules. P0 is the highest priority and
P3 is the lowest.
802.1p
You can choose from 0 to 7.
Delete
Select a row in the QoS rule list and click it to delete the row.
Delete all
Select all the rows in the QoS rule list and click it to delete the
rows.
Page 108 / 134
DG-BG4100N User
Manual
108
3.6.5
SNMP
Choose
Advance > SNMP
, and the page shown in the following figure appears. You can
configure the SNMP parameters.
The following table describes the parameters of this page:
Field
Description
Enable SNMP
Select it to enable SNMP function. You need to enable
SNMP, and then you can configure the parameters of this
page.
System Description
System description of the DSL device.
System Contact
Contact person and/or contact information for the DSL
device.
System Name
An administratively assigned name for the DSL device.
System Location
The physical location of the DSL device.
Trap IP Address
Enter the trap IP address. The trap information is sent to the
corresponding host.
Community Name
(Read-only)
The network administrators must use this password to read
the information of this router.
Community Name
(Read-Write)
The network administrators must use this password to
configure the information of the router.
Page 109 / 134
DG-BG4100N User
Manual
109
3.6.6
Others
Choose
Advance > Others
, and the page shown in the following figure appears. The page
that is displayed contains Bridge Setting, Client Limit, Tunnel and Others.
3.6.6.1 Bridge Setting
Choose
Advance > Bridge Setting
, and the page shown in the following figure appears.
This page is used to configure the bridge parameters. You can change the settings or view
some information on the bridge and its attached ports.
The following table describes the parameters and button of this page:
Field
Description
Ageing Time
If the host is idle for 300 seconds (default value), its entry is
deleted from the bridge table.
802.1d Spanning
Tree
You can select Disable or Enable.
Select Enable to provide path redundancy while preventing
undesirable loops in your network.
Show MACs
Click it to show a list of the learned MAC addresses for the
bridge.
Page 110 / 134
DG-BG4100N User
Manual
110
Click
Show MACs
, and the page shown in the following figure appears. This table shows a
list of learned MAC addresses for this bridge.
3.6.6.2 Client Limit
Choose
Client Limit
in the left pane, and the page shown in the following figure appears.
This page is used to configure the capability of forcing how many devices can access to the
Internet.
19216811.live