Page 111 / 134
Scroll up to view Page 106 - 110
DG-BG4100N User
Manual
111
3.6.6.3 Tunnel
Choose
Tunnel
in the left pane, and the page shown in the following figure appears. You
may configure tunnels to connect to ipv4 and ipv6 networks.
The following table describes the parameters and button of this page.
Field
Description
General v6inv4
Tunnel
Specify
the
general
v6inv4
tunnel,
ipv6
packet
is
encapsulated in ipv4 packets,
Interface Name
Select the tunnel interface name, user can set 2 v6inv4
tunnel.
Tunnel Endpoints
Specify the ipv4 address for tunnel endpoints.
Local IPv6 Address
Specify the ipv6 address for tunnel local.
Page 112 / 134
DG-BG4100N User
Manual
112
Current General
Tunnel Table
Display current general v6inv4 tunnel setting.
Enable
Enable or disable the DS-Lite tunnel.
Interface
Select current wan interface used as tunnel interface.
Mode: 6to4 Tunnel
Enable or disable special tunnel.
3.6.6.4 Others
Choose
Others
in the left pane, and the page shown in the following figure appears. You can
enable half bridge so that the PPPoE or PPPoA connection will set to Continuous.
Page 113 / 134
DG-BG4100N User
Manual
113
3.7
Admin
In the navigation bar, click Admin. The Admin page that is displayed contains
Commit/Reboot, Update, Log, Password and Time.
3.7.1
Commit/Reboot
Choose
Admin > Commit/Reboot
, and the page shown in the following figure appears. You
can set the router reset to the default settings or set the router to commit the current settings.
The following table describes the parameters and buttons on this page:
Field
Description
Reboot from
You can choose Save current configuration or Factory default
configuration.
Save current configuration: Save the current settings, and
then reboot the router.
Factory default configuration: Reset to the factory default
settings, and then reboot the router.
Commit
Changes
Click it to apply the changes
Reset
Click it to undo the selection.
Reboot
Click it to reboot the router.
Page 114 / 134
DG-BG4100N User
Manual
114
3.7.2
Update
Choose
Admin > Update
. The Update page that is displayed contains Upgrade Firmware
and Backup/Restore.
Caution:
Do not turn off the router or press the Reset button while the procedure
is in progress.
3.7.2.1 Upgrade Firmware
Click
Upgrade Firmware
in the left pane, and the page shown in the following figure
appears. In this page, you can upgrade the firmware of the router.
The following table describes the parameters and button of this page:
Field
Description
Select File
Click Browse to select the firmware file.
Upload
After selecting the firmware file, click Upload to starting
upgrading the firmware file.
Reset
Click it to undo the selection.
Page 115 / 134
DG-BG4100N User
Manual
115
3.7.2.2 Backup/Restore
Click
Backup/Restore
in the left pane, and the page shown in the following figure appears.
You can backup the current settings to a file and restore the settings from the file that was
saved previously.
The following table describes the parameters and button of this page:
Field
Description
Save Settings to File
Click it, and select the path. Then you can save the
configuration file of the router.
Load Settings from File
Click Browse to select the configuration file.
Upload
After selecting the configuration file of the router, click
Upload to start uploading the configuration file of the
router.
19216811.live