19216811.live79
PROGRAMMING
MY HOME
GUIDE
CONTROL
The dialling device field of application concerns 4 areas:
Calls with pre-recorded
message, following a
burglar-alarm system
message. The calls
are divided into 4
channels and up to 4
telephone numbers can
be associated to each
of them.
Following events (see
table), automations are
generated by means of
OWN codes
Following a detected
alarm, by telephoning
home one can listen
in the room and give
messages
4 short telephone
numbers which are
easy to remember, to
which 4 OWN codes are
associated, to generate
automations
Telephone commands
typing the OWN codes
ALARM
MANAGEMENT
AUTOMATIONS
ROOM
MONITOR
TELEPHONE
COMMANDS
Each of the possibilities of operation described above is obtained by suitably setting
and programming the device. Each programming is thus divided into two phases:
1 SET THE BASE FUNCTIONS:
corresponds to the entering of all the
data needed for the dialling device to work properly (e.g. date,
time…)
2 PROGRAM THE OPERATIONS:
corresponds to the programming of
all the actions which one hopes to perform by means of the dialling
device (e.g. room monitor, telephone commands).
PROGRAMMING
THE OPERATIONS
SET THE BASE
FUNCTIONS
1ST
PHASE
2ND PHASE
OWN= OPEN WEB NET
SAFETY
COMMANDS
PROGRAMMING - Burglar alarm control unit
with dialling device and telephone dialling device
Programming takes place by means of the keypad under the display.
ok
ann
³at 01 Jan 2000
10:15
Programming keypad and display
Cancelling the selection or
cancelling entered or pre-set data
Confirming the selection displayed
or data entering
Can select the various menu
operations and move the cursor
in the display to modify the data
entered
The dialling device has a series of MENUS, which can be displayed on the
monitor and selected by means of a programming keypad, and where data
can be selected or entered.
M´NU
cH±NG´ N. JOLLY
For detailed information on programming procedures, please see the
instruction manual supplied with the telephone dialling device.
NOTE:
The procedure described above is specific for the programming of
telephone dialling device item N4075. To set the burglar alarm control
unit with integrated telephone dialling device, use the TiSecurity Software
supplied with item 3500, 3500N and 3500GSM. For additional information,
please see the documentation provided with the control unit.
When the
symbol is shown on the second line of the display, this
indicates that other options are available in the menu chosen which can be
selected with the
and
.
After a few seconds, if no key is pressed, the dialling device returns to the
display date and time mode.