19216811.live64
MY HOME - CONTROL
GENERAL RULES FOR INSTALLATION
Telephone actuator
USE
Activation, deactivation and check commands
The activation, deactivation and check commands must only be sent to the
actuator from a telephone with touch tone dialling (DTMF) connected to the
fixed-line or the mobile network (mobile phone), while using telephones
with pulse dialling (PD) or rotary dial the actuator does not work.
Two types of command can be sent to the telephone actuator:
Simplified commands
Commands formed of a small number of characters to type.
Complete commands (Open Web Net)
Commands formed of a large number of characters.
These commands belong to the BTicino “Open Web Net” protocol and are
common to all the products belonging to the My Home family.
To use the actuator, the PROG/LINE selector (on the front part) should be
moved to LINE and the green light should be permanently on. Activation,
disabling, and check controls can be sent from an external line.
Using the
check command one can check the operating condition of the user (activated
or deactivated) from a fixed-line or mobile telephone line.
If an answering machine is also present on the same telephone line, all
actuators should be set to answer after the answering machine, setting a
higher number of rings than those set for the activation of the answering
machine.
The actuators only answer after a valid number of consecutive rings (call
from outside telephone line or internal call from extension connected to the
switchboard) which is the same as those programmed (base 5) while invalid
rings are those produced by an auto-dial call.
Simplified commands for remote operation from telephone
This is the simple version of the activation, deactivation and check
commands. These are made up of a limited number of characters, for easy
use.
These commands can activate, deactivate or check the state of the relays
of the main and secondary actuators and are valid for all modes - lighting,
automatic operation and temperature regulation.
LOCALE COMMANDS THROUGH FRONT PUSHBUTTONS
The C1 and C2 pushbuttons allow to control (activate and deactivate) the
relays in relation to the mode and function set.
The C1 pushbutton activates relay 1, the C2 pushbutton activates relay 2.
C1
C2
PROG
F461/2
LINEA
PRI
LU
c1
c2
a
b
230V
230V
0,5±
2±
5±
²os=0,5
6±
50 Hz
50 m±
C1
C2