Page 121 / 138
Scroll up to view Page 116 - 120
Management and Diagnostic Console
116
The Route List shows a list of static routes defined by the user. For each user-defined static route, the
following information is displayed:
•
Subnet IP
•
Subnet Mask
•
Gateway
•
Interface
Page 122 / 138
Management and Diagnostic Console
117
Advanced - DNS Resolve Page
The Advanced - DNS Resolve page allows users to name network devices (such as printers or Web servers)
so that they may be easily accessed by other users on the network.
Figure 50. MDC Advanced DNS Name Table Page
To add entries to the Name table:
1.
In the DNS name field, enter a name for the device.
2.
In the IP Address field, enter the device’s IP address.
3.
Click
ADD
.
4.
The Name table displays the name you defined for each device, the device’s IP address, and the entry
type. To remove the device from the Name table, click the
Remove
button.
Note:
To access this page, your network must have the Remote Management feature enabled.
If the feature is not enabled, an error message will display when you click the link to access
this page.
Page 123 / 138
Management and Diagnostic Console
118
Advanced - Traffic Shaping Page
The Advanced - Traffic Shaping page allows users to change the 2Wire gateway’s maximum upstream
connection rate.
Figure 51. MDC Advanced Traffic Shaping Page
To change the gateway’s upstream connection rate:
1.
Check the
Enable Traffic Shaping
checkbox.
2.
In the New Upstream Rate field, enter the upstream rate at which you want the gateway to connect.
3.
Click the
Submit
button.
Note:
To access this page, your network must have the Remote Management feature enabled.
If the feature is not enabled, an error message will display when you click the link to access
this page.
Warning:
Modifying the gateway’s configuration settings may impede or interrupt the user’s
broadband service, or violate the service provider’s service level agreement.
Page 124 / 138
Management and Diagnostic Console
119
Advanced - Link Manager States Page
The Advanced – Link Manager States page is a tree representation of the 2Wire gateway interface stack,
and shows the internal state of the 2Wire gateway.
Figure 52. MDC Advanced Link Manager States Page
The Link Manager States page is used to gather dynamic information on internal networking modules, and
is based on the runtime configuration of the 2Wire gateway. The information cannot be used to configure
the 2Wire gateway.
Page 125 / 138
Management and Diagnostic Console
120
To view information about each node, click the node link. Information displays below the Link Manager
States tree, and includes the following:
Node Information
Description
Link status
Up.
The link is functioning properly.
Climbing.
The link is attempting to establish a connection.
Down.
The link is not yet configured.
Error.
An error has occurred.
State changes
The number of times the state of the link has changed (since last
reboot).
19216811.live