1. Home
    2. /
  2. Manuals
    3. /
  3. 2Wire
    4. /
  4. 2701HGV-W
    5. /
  5. 28
Page 136 / 138 Scroll up to view Page 131 - 135
131
Regulatory Information
Electrical
AC Adapter
The AC adapter is designed to ensure your personal safety and to be compatible with this equipment. Please follow these guidelines:
• Do not use the adapter in a high moisture environment. Never touch the adapter when your hands or feet are wet.
• Allow adequate ventilation around the adapter. Avoid locations with restricted airflow.
• Connect the adapter to a proper power source. Voltage and grounding requirements are found on the product case and/or
packaging.
• Do not use the adapter if the cord becomes damaged.
• Do not attempt to service the adapter. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess
moisture.
Telecommunication Cord
CAUTION:
To reduce the risk of fire, use only No. 26 AWG or larger UL Listed or CSA Certified Telecommunication Line Cord.
Location – Electrical Considerations
WARNING:
The electrical cord of this product must be plugged into a properly grounded outlet or adapter.
Failure to comply could
result in an electric shock hazard.
If you do not know whether your outlet or adapter is properly grounded, you should consult a
licensed electrician.
CAUTION:
Due to risk of electrical shock or terminal damage, do not use the terminal near water, including a bathtub, wash bowl,
kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Also, avoid using this product during electrical storms. Avoid
locations near electrical appliances or other devices that cause excessive voltage fluctuations or emit electrical noise (for example, air
conditioners, neon signs, high-frequency or magnetic security devices, or electric motors).
Equipment
Repairs
Do not, under any circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, contact your local 2Wire
distributor or service provider for assistance. Failure to comply may void the product warranty.
Location – Environmental Considerations
Do not plug the power pack into an outdoor outlet or operate the terminal outdoors. It is not waterproof or dustproof, and is for indoor
use only. Any damage to the unit from exposure to rain or dust may void your warranty.
Do not use the terminal where there is high heat, dust, humidity, moisture, or caustic chemicals or oils. Keep the gateway away from
direct sunlight and anything that radiates heat, such as a stove or a motor.
Declaration of Conformity
FCC Compliance
The following device has been tested and certified as compliant with the regulations and guidelines set forth in Part 68 of FCC
Rules:
Manufacturer:
2Wire, Inc.
Model:
2701HGV-W
Part 15 of FCC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Page 137 / 138
Regulatory Information
132
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to
operate this equipment.
Part 68 of FCC Rules
This equipment complies with Part 68 of the FCC Rules. On the modem board inside full featured base stations is a label that
contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested,
this information may be provided to the telephone company.
The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on the telephone
line may result in the device not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not
exceed five (5.0).
L’indice d’équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de terminaux qui peuvent être raccordés à une interface
téléphonique. La terminaison d’une interface peut consister en une combinaison quelconque de dispositifs, à la seule condition que
la somme d’indices d’équivalence de la sonnerie de tous les dispositifs n’excède pas 5.
To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone
company to determine the maximum RENs for the calling area.
This terminal cannot be used on telephone-company-provided coin service. Connection to Party Line Service is subject to state tariffs.
This equipment uses the following USOC jacks: RJ11C, RJ45 (WAN/Ethernet)
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the
telephone network or premises wiring using a compatible modular jack that is Part 68 compliant. If this equipment causes harm to the
telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. If
advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your
right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the operation of this equipment. If this happens, the telephone company will
provide advance notice in order for you to make the necessary modifications to maintain uninterrupted service. If trouble is
experienced with this equipment, please contact 2Wire, or your local 2Wire distributor or service center in the U.S.A. for repair and/or
warrant information. If the trouble is causing harm to the telephone network, the telephone company may request you to remove this
equipment from the network until the problem is resolved. No repairs can be done by a customer on this equipment. It is
recommended that the customer install an AC surge arrestor in the AC outlet to which this device is connected. This is to avoid
damage to the equipment caused by local lightning strikes and other electrical surges.
RF Exposure Information
This device was verified for RF exposure and found to comply with Council Recommendation 1999/519/EC and FCC OET-65 RF
exposure requirements.
Wi-Fi Only
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. For additional compliance
information, please reference FCC ID: PGR2W2701.
Page 138 / 138
MPE/SAR Labeling
WARNING: While this device is in operation, a separation distance of at least 20 cm (8 inches) must be maintained between the
radiating antenna inside the Equipment Under Test (EUT) and the bodies of all persons exposed to the transmitter in order to meet the
FCC RF exposure guidelines. Making changes to the antenna or the device is not permitted. Doing so may result in the installed
system exceeding RF exposure requirements. This device must not be co-located or operated in conjunction with any other antenna or
radio transmitter. Installers and end users must follow the installation instructions provided in this guide.
PTC General Warning
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with
minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort
of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted
equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services.

Rate

3.5 / 5 based on 2 votes.

Popular 2Wire Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top