Page 111 / 138
Scroll up to view Page 106 - 110
Management and Diagnostic Console
106
Advanced - Provisioning Info Page
The Advanced – Provisioning Info page displays the parameters with which the 2Wire gateway was
provisioned.
Figure 46. MDC Advanced Provisioning Information Page
Page 112 / 138
Management and Diagnostic Console
107
The gateway provisioning parameters are dynamic, and vary depending on the software version that the
gateway is running.
•
Module Configuration. Configuration parameters for modules listed in the Advanced Link Manager
States page. The parameters are set by broadband provisioning.
•
UI Param Configuration. Configuration parameters that affect the user interface and user interaction.
The parameters are set by broadband provisioning.
•
Server Set Configuration. Configuration information defining how the gateway is connected to and
interacts with backend provisioning.
•
Firewall Configuration. Configuration information for the firewall.
Page 113 / 138
Management and Diagnostic Console
108
Advanced - Configure Time Services Page
The Advanced – Configure Time Services page allows you to view and change system time and date
settings.
Figure 47. MDC Advanced Configure Time Services Page
During the 2Wire gateway setup process, you specify the time zone in which you are located so that the
time and date are automatically displayed in the 2Wire gateway user interface. These time settings are
displayed in the Current Time Settings panel, which shows the current date, time, time zone, and whether
the time was automatically or manually configured. If you wish to manually set the time and date, you can
do so in the Manually Set Time/Date panel.
Note:
To access this page, your network must have the Remote Management feature enabled.
If the feature is not enabled, an error message will display when you click the link to access
this page.
Page 114 / 138
Management and Diagnostic Console
109
To manually set the time and date:
1.
Check the
Enable
checkbox.
2.
In the Time field, enter the time in 24-hour HH:MM:SS format (for example, 10:02:11).
3.
In the Date field, enter the date in YYYY/MM/DD format (for example, 2006/10/09).
4.
From the Time Zone pull-down menu, select the time zone. The available time zones are Hawaii, Alaska,
Pacific, Mountain, Arizona, Central, Eastern, Indiana, and Atlantic (Canada).
5.
Check the
Daylight Savings Time
checkbox if you wish to automatically adjust for daylight savings time.
You can also specify the time servers from which you wish to obtain system time by entering the time server
Internet address in the Time Servers fields. These settings are typically provided by the service provider
and/or backend management system.
Page 115 / 138
Management and Diagnostic Console
110
Advanced - Configure Services Page
The Advanced – Configure Services page allows you to enable the 2Wire gateway to operate in bridged
mode, change the timeout settings for NAT, enable notification messages, enable the SIP ALG, and change
the upstream maximum transmission rate.
Figure 48. MDC Advanced Configure Services Page
Routing
By default, the 2Wire gateway is configured in routed mode. The Advanced – Configure Services page allows
you to configure the 2Wire gateway to operate in bridged mode.
Note:
To access this page, your network must have the Remote Management feature enabled.
If the feature is not enabled, an error message will display when you click the link to access
this page.
19216811.live