Page 16 / 39
Scroll up to view Page 11 - 15
Page 16 of 39
SETTINGS > APN:
•
Press Disconnect to disconnect from the Network
•
Press Add New to create a new APN
•
Add the Profile Name, eg Telstra WAP
•
Enter the correct APN details eg telstra.wap
•
Press Save to save your new APN
•
Press the Profile drop down box
•
Select the new APN profile name
•
Click on ‘Set as default’ to set the new APN as your preferred setting
•
Press the Help icon
to get in context tips.
•
Normally there is no need to change these settings unless you change service
provider or are instructed by your carrier.
•
The modem is locked to Telstra. If you use a SIM card from another provider you
Page 17 / 39
Page 17 of 39
may not be able to connect to the network.
•
Consult your new carrier to obtain alternate APN details for your device.
SETTINGS > WI-FI SETTINGS > BASIC SETTINGS:
The SSID is the Wi-Fi Network Name for your device
•
By default the SSID and Password is shown on the front screen. Select Disable on
“Display SSID and Password On Screen” to hide this information.
•
You can change the SSID to something more memorable or personal
•
You can hide the SSID broadcast so unknown users will not even see your
network
•
You can change the security settings and password to suit your own preferences
•
You can set the number of available connections between 1 and 10. The default
setting for 5 users is to improve battery life and Wi-Fi data throughput.
•
Press Apply to save your changes
•
Press the Help icon
to get in context tips
Page 18 / 39
Page 18 of 39
SETTINGS > WI-FI SETTINGS > ADVANCED SETTINGS
•
You can change the Wi-Fi settings to suit your personal choices or for specific
requirements of your attached devices.
•
Press Apply to save your changes
•
Press the Help icon
to get in context tips
Page 19 / 39
Page 19 of 39
SETTINGS > WI-FI SETTINGS > WPS
•
WPS uses the push button on the front panel to connect seamlessly to
supported devices.
•
Press WPS to enable, compatible devices can connect to your Wi-Fi network
without authorisation, or you can set a PIN if required.
•
WPS is enabled for 2 minutes once pressed and the device LED’s will flash to
indicate WPS mode.
•
If you have enabled PIN mode then you need to enter the same PIN on devices
you wish to connect.
•
Press the Help icon
to get in context tips
Page 20 / 39
Page 20 of 39
SETTINGS > DEVICE SETTINGS > ACCOUNT
MANAGEMENT
•
Use the Account Management settings to change the administrator password if
required.
•
The default password is password. If you have changed and forgotten the
password then you need to restore the device to factory defaults:
1. With the device switched on open the SIM slot cover and locate the reset
button next to the SIM slot.
2. Using an item such as a paperclip or pin press and hold the “Reset” button for
5 seconds.
3. The display will flash and the device will re-boot to factory default settings.
•
Press the Help icon
to get in context tips
19216811.live